User Account

All Pages

This cycle is operated at 80 kpa and 20oc at the beginning

Assignment Help Mechanical Engineering
Reference no: EM13632796

An air-standard dual cycle has a compression ratio of 14 and a cut-off ratio of 1.2. The pressure ratio during the constant-volume heat addition process is 1.5. This cycle is operated at 80 kPa and 20oC at the beginning of the compression step. Assume constant properties evaluated at 300 K. Determine the following:

a) The maximum pressure of the cycle.

b) The amount of heat added.

c) The thermal efficiency.

Reference no: EM13632796

Questions Cloud

Why is it preferable to use nuclear binding energy per : why is it preferable to use nuclear binding energy per nucleon for a comparison of the stabilities of different
Determine the entropy generation kjkg-k for the compressor : saturated liquid water is compressed from 100 kpa state 1 to 2.5 mpa state 2 in an adiabatic pump having 85 isentropic
Methabe reacts withoxygen in the air to produce carbon : methabe reacts withoxygen in the air to produce carbon dioxide and water. ammoniareacts with oxygen in the air to
A convex lens is held over a piece of paper outdoors on a : a convex lens is held over a piece of paper outdoors on a sunny day. when the paper is held 21 below the lens the
This cycle is operated at 80 kpa and 20oc at the beginning : an air-standard dual cycle has a compression ratio of 14 and a cut-off ratio of 1.2. the pressure ratio during the
Scl2 state the molecular polarity in a 3d sketch of : scl2 state the molecular polarity in a 3d sketch of youmolecule and lable the dipole moment of each bond state
Two circular coils carry the same current but one coil has : two circular coils carry the same current but one coil has twice the diameter of the other one. if the larger coil
What is the difference between steady state and non steady : what is the difference between steady state and non steady state diffusion procces? use mathematical expresions for
How many moles of na ions are there in 1 mole ofna2so4 do : how many moles ofna ions are there in 1 mole ofna2so4 ? do you simply have to divide the relative atomic mass of na

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The duration of the impact is 0002 seconds determine the

a 2-kg sphere a is moving toward the right at 4 ms when it strikes the end of a 5 kg slender bar b. the coefficient of

  Test the hypothesis that both machines fill to the same net

two machines are used for filling glass bottles with a soft-drink beverage. the filling process have known standard

  What error in the pressure drop would ensue if the

water is flowing turbulently at a mean velocity of um10 fts in a 1.0 - in. i.d. horizontal pipe and the fanning

  Estimate the safety factor with respect to infinite fatigue

a 20 mm diameter shaft with a 6 mm diameter transverse hole is made of cold-drawn steel having ultimate strength 550

  How does this subcooling change the power required to drive

round your final answers to three decimal places. the liquid leaving the condenser of a 115000-btuh heat pump using

  A 02 lb block is initially moving horizontally at 5 fts

a 0.2 lb block is initially moving horizontally at 5 fts when r1 4 ft it slides around the smooth inside surface of

  A system contains refrigerant r-134a with the specific

1. a system contains water at 4.0 mpa and 275 degc. the phase of water isa liquid onlyb liquid-vapor mixturec vapor

  Determine the fraction of the throttle mass flow that

consider a regenerative rankine cycle with a 600c and 4-mpa throttle a 5-kpa condenser and an open feedwater heater at

  A partitioned chamber that is well insulated has frac12

a partitioned chamber that is well insulated has frac12 filled with h2o at 500 deg f and 50 psia and the other frac12 a

  Determine the force that needs to be applied on the play to

a thin 30 cm x 30 cm flat plate is pulled at 3 ms horizontally through a 3.6 mm think oil layer sandwiched between two

  A certain object weighs 300 n at the earths surface

a certain object weighs 300 n at the earths surface. determine the mass of the object in kilograms and its weight in

  A shell-and-tube heat exchanger consisting of one shell

a shell-and-tube heat exchanger consisting of one shell pass and two tube passes is used to transfer heat from an

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd