User Account

All Pages

Theoretical maximum and minimum values

Assignment Help Electrical Engineering
Reference no: EM13869747

Problem 1: A buck-boost converter has an voltage Vin = 10 V, switching frequency fs = 100 kHz, duty ratio d = 30%, load resistance RL = 20 Ω, inductance 100 µH, and capacitance 680 µF.

Problem 2: Sketch the following waveforms, and include the theoretical maximum and minimum values of each waveform:

a) q(t)

b) vDS

c) vdiode

d) vL

e) iL

f) idiode

g) iC

Reference no: EM13869747

Questions Cloud

How much should the stock price change in dollars : How much should the stock price change (in dollars and percentage)?(Do not round intermediate calculations and round your final answers to 2 decimal places.)
Can everyone be an online learner? : Can everyone be an online learner?
The partial sale of the investment : On January 1, 2010, the Mark Corporation purchased bonds with a face value of $500,000 for $475,413.60.
What would be the stock price in five years : If this growth rate continues, what would be the stock price in five years if the P/E ratio remained unchanged? What would the price be if the P/E ratio increased to 25 in five years?(Round your answers to 2 decimal places.)
Theoretical maximum and minimum values : Sketch the following waveforms, and include the theoretical maximum and minimum values of each waveform:
Discuss what the costume design tells the viewer : discuss what the costume design tells the viewer
What is value of limited brands stock when required return : What is the value of Limited Brands stock when the required return is 13.5 percent? Financial analysts forecast Limited Brands (LTD) growth rate for the future to be 11.5 percent.
Species of animals seem to prefer social living environments : species of animals seem to prefer social living environments
Prepare the journal entry for this sale, assuming : On January 1, 2009 Snow Corporation purchased 20% of the 200,000 outstanding shares of common stock of Garvey Company for $4.00 per share as a long term investment.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How does the maximum power compare with the nominal rating

(a) If a motor at the end of a transmission line has a reactance of 8 ohms per phase, what is the maximum power which the machine can develop, given that the sender voltage is 4kV and the induced voltage Eo is also 4kV.

  What is an alternative to using a higher order anti-aliasing

1. A transfer function of a low pass filter may be divided into which three response ranges Actual response, ideal response, and straight-line response Gain, ripple, and roll-off Pass band, roll-off, and stop band Attenuation, gain, and roll-off

  Compute the image frequency and its db of suppression

An AM broadcast receiver's pre-selector has a total effective Q of 90 to a received signal at 1180 kHz and uses an IF of 455 kHz. Calculate the image frequency and its dB of suppression.

  Select two different applications that use electrical wiring

Select two different applications that use electrical wiring.

  Find the total chargeq that is contained in a circular disk

The surface charge density throughout the z = 0 plane isρs = 1/ρ[C/m2],where ρ is specified in meters. Find the total chargeQ that is contained in a circular disk of radius 1.0[m]that is centered about the origin in the same plane.

  Find the resistance of an electric light bulb for a current

1.) Find the resistance of an electric light bulb if there is a current of a 0.8 A and a voltge potential diference of 120V. 2.) A light bulb uses 1.2A when connected across a 120Vsource. What power is used by the bulb

  Coefficient of kinetic friction

In the system shown below Block A has a mass of 15kg and Block B has mass 5k2. It is measured that the tension in the cable is 40N. Determine the acceleration of Block A and the coefficient of kinetic friction between Block A and the ground (negle..

  Compute the fading margin in gsm uplink

Consider a gsm uplink.the ms has 100 mw transmit power and the sensitivity of the bs receiver is -105 dbm.the distance between the bs and ma is 500 m.the propagation law follows the free space law up to a distance of dbreak=50m

  Write out by hand an estimate of the water level in storage

A cylindrical storage tank with cross sectional area A.contains a liquid at a depth "y", defined such that y=0 when thetank is half full. Liquid is withdrawn from the tank at a volumeflow rate of (Alpha*(1+y)^3/2)/A)

  Calculate and plot ß for a p-n-p bjt with lnp

The current amplification factor β of a BJT is very sensitive to the base width as well as to the ratio of the base doping to the emitter doping. Calculate and plot β for a p-n-p BJT with Lnp = Lpn for: (a) nn = pp and Wb/Lnp = 0.01 to 1

  Calculate generated emf and regulation of the alternator

A 3-phase,4pole star connected turbo alternater has a cylindrical rotar. The reactance and resistance perphase of winding is 2.5 ohms and 0.15 ohms.The alternater hasterminal potential difference of 6600V when delivering a current of250Amps.

  Develop a digital logic circuit utilizing the skills

Objective: Develop a digital logic circuit utilizing the skills gained in EE202 to create a circuit capable implementing a Hamming error correction code. Description: The data transmitted through you're the system is stored in 8 bit (1 byte) words. I..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd