The water in the pool is 25 feet deep and the rim of the

Assignment Help Mechanical Engineering
Reference no: EM13623616

A garden hose is open at one end and capped closed at the other. A swimmer in an above-ground pool fills the hose with pool water, then throws the capped end out of the pool. The open end of the hose sits at the bottom of the pool, and the capped end sits on the ground just outside the pool and level to the bottom of it. The external pressure is 1 atm. The water in the pool is 2.5 feet deep, and the rim of the pool is 3.5 feet above the ground. What is the water pressure in the capped end of the hose? What is the water pressure at the maximum height of the hose? You can assume that there are no air bubbles in the hose. (Hint: The correct answers are not 1 atm.)

Reference no: EM13623616

Questions Cloud

View this energy as stored in the electrostatic field : the plates of a parallel plate capacitor have an area of 90 cm2 each and are separated by 2.5 mm. the capacitor is
What is the area of the plates of a 2 f parallel plate : what is the area of the plates of a 2 f parallel plate capacitor given that the separation between the plates is 0.5
How high above the ground is the balloon at the instant the : the position of an object is moving along an x axis is given by x3t - 4t2t3 where x is in meters and t is in
As the chain is raised assuming that the motor supplies a : a ships anchor chain is wrapped around a hollow steel drum of mass m 500 kg and radius r 0.5m. the drum is located on
The water in the pool is 25 feet deep and the rim of the : a garden hose is open at one end and capped closed at the other. a swimmer in an above-ground pool fills the hose
If at a given instant r 71 miles and theta 34 degrees : a radar station is tracking a plane flying at constant altitude with a speed of v0 600 mph. if at a given instant r
A large number of 1 microf capacitors are available to him : an electrical technician requires a capacitance of 2 microf in a circuit across a potential difference of 1 kv. a large
A batch of 25 injection-molded parts contains five that : a batch of 25 injection-molded parts contains five that have suffered excessive shrinkage. if two parts are selected at
Two charged conducting spheres of radii a and b are : two charged conducting spheres of radii a and b are connected to each other by a wire. what is the ratio of electric

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What is the rotating speed of the disk in rpm

A slotted disk and opto-interrupter outputs pulses at 62 HZ. The disk has only one slot cut in it. what is the rotating speed of the disk in rpm?

  Examine the influence of the vibration on the grain size

Examine the influence of the vibration on the grain size, microstructure and mechanical properties of aluminium-silicon alloys (Al-Si) during solidification.

  A 3-lb collar can slide on a horizontal rod which is free

a 3-lb collar can slide on a horizontal rod which is free to rotate about a vertical shaft. the collar is intially held

  Define the torsion moment

Calculate spring coefficient k = P/δ and discuss the design on how much spring radius r should be changed to increase k two times

  Diffusion coeffiecient and calculate constant

Diffusion Coeffiecient, Calculate Constant, The diffusion coeffiecient for Cr^+3 in Cr2O3 is 6x10^-15 cm2/s at 727 degrees Celcius and is 1x10^-9 cm2/s at 1400 degrees Celcius.

  The average speed of blood leaving the left ventricle is

blood flows from the left ventricle of the heart up through the ascending aorta. this system can be modeled as a

  Explain compressive stress

Important information about Compressive Stress, A circular cross sectional bar with a diameter of 3.25 inches is loaded with a uniform axial compressive load of 22,750 pounds. What is the compressive stress along a cross section of the bar?

  Te volume of the air slowly decreases to 0002 m3 in a

air is contained in a vertical piston-cylinder assembly by a piston of mass 50 kg and having a face area of 0.01 m2.

  One kg of water vapor at 200 kpa fills the 11989 m3 left

one kg of water vapor at 200 kpa fills the 1.1989 m3 left chamber of a partitioned system. the right chamber has twice

  Devise and evaluate the exergetic efficiency for cycle

Consider a cold air-standard Diesel cycle. Operating data at principal states in the cycle are given in the table below.For k=1.4 Cv=0.718kJ/(kg*k), and Cp= 1.005 kJ/(kg*K)

  What becomes of the extra energy

B) Determine the minimum amount of work [kJ ] required to reach this end state. C) If more than the minimum work is actually used, where does this extra energy go? That is what becomes of the extra energy?

  The valve is opened long enough to fill the tank to a

an insulated rigid tank with a volume of 10ft3 is connected by a valve to a supply line containing steam at 500 psia

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd