The velocity of a particle along the s-axis

Assignment Help Mechanical Engineering

Reference no: EM13703033

The velocity of a particle along the s-axis is given by v = 17s^3/2 where s is in millimetres and v is in millimetres per second. Determine the acceleration when s is 3.3 millimetres.

Reference no: EM13703033

Questions Cloud

Find the power input to the compressor : A steam compressor receives H 2O at 90kPa and 75% quality at a rate of 50 kg/s. Part way through the compressor, steam is bled off at 20kg/s, 2MPa and 300C. The remainder exits the compressor at 10MPa, 500C. Assuming heat transfer and changes in po..

Determine the analysis in terms of mole fractions : The analysis of a mass basis of an ideal gas mixture at 50 F, 25 lbf/in2. is 60% CO2, 25% SO2, and 15% N2. The analysis in terms of mole fractions. Determine: The apparent molecular weight of the mixture. The partial pressure of each component in lbf..

What will be the approximate density of the boat hull : A group of mechanical engineers like catamaran sailing on the Great Salt Lake and decide to use a glass-fiber reinforced composite with a high fiber fraction for a new boat design. The composite is 60 volume % SiO2 glass fibers and the remainder is a..

Determine the thermal efficiency of a carnot cycle operating : An ideal Otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 540R and 2400R.

The velocity of a particle along the s-axis : The velocity of a particle along the s-axis is given by v = 17s^3/2 where s is in millimetres and v is in millimetres per second. Determine the acceleration when s is 3.3 millimetres.

Many ventilation systems maintain a slightly higher pressure : Many ventilation systems maintain a slightly higher pressure in a building than the outside pressure. If the pressure in your room is 0.1 psi than the outside pressure will you be able to open the door? How much is this force compared to your weight?..

Diamond-zirconium oxide-argon gas and rubber-bronze : What type(s) of bonding would be expected for each of the following materials? Diamond, Zirconium Oxide, Argon Gas, Rubber, Bronze (a mixture of copper and tin)

Determine torque and power required to rotate inner cylinder : The space between two 6 in. long concentric cylinders is filled with glycerin (viscosity = 8.5X10-3 lb s/ft2). The inner cylinder has a radius of 3 in. and the gap width between the cylinders is 0.1 in. Determine the torque AND power required to rota..

Direct tension-direct compression and column buckling : Describe when each type of failure occurs: direct tension, direct compression, column buckling, direct shear, torsional shear stress, bending stress

User Account

All Pages