The vapor is to be saturated at the outlet of the turbine

Assignment Help Mechanical Engineering

Reference no: EM13708114

A Rankine cycle with superheat is to be designed using water as the working fluid. The boiler pressure will be 1000 psia and the peak temperature will be 900 Â°F. (a) Determine the temperature required for the condenser if the expansion through the turbine is isentropic, and the vapor is to be saturated at the outlet of the turbine. (b) Determine the temperature of the condenser if the expansion through the turbine is isentropic, but the vapor leaving the turbine is to have a quality of 94%. (c) Determine the temperature of the condenser if the turbine operates with an adiabatic turbine efficiency of 94%, and the vapor leaving the turbine is to be saturated.

Reference no: EM13708114

Questions Cloud

Insulated piston-cylinder-determine voltage of the soured : An insulated piston-cylinder device contains 7L of saturated liquid water at a constant pressure of 175 kPa. Water is stirred by a paddle wheel while a current of 6.2A flows for 75 min through a resistor placed in the water. If one half of the liquid..

Injection molding machine-what is minimum clamp tonnage : The bottom of a chair (where you sit, the ‘seat’) will be injection molded by itself in a mold. Assume the chair is a disk, 24 inches in diameter and 1/10 inch thick. If the injection pressure is 1600 psi, what is the minimum clamp tonnage you need f..

What is the total rate of their heat transfer : Metal balls 10 mm in diameter are to be annealed by heating them to 827°C then allowing them to cool slowly in air at 27Â°C to the point where they are in thermal equilibrium with the air. 2000 balls are annealed in one hour’s time. What is the total..

Determine volume of the tank and amount of heat transfer : A rigid tank contains 10 lbm of air at 30 psia and 65°F. The air is now heated until its pressure doubles. Determine (a) the volume of the tank and (b) the amount of heat transfer.

The vapor is to be saturated at the outlet of the turbine : A Rankine cycle with superheat is to be designed using water as the working fluid. The boiler pressure will be 1000 psia and the peak temperature will be 900 Â°F. (a) Determine the temperature required for the condenser if the expansion through the t..

Determine the mass of the refrigerant in the tank : A 0.5-m3 rigid tank contains refrigerant-134a initially at 160 kPa and 40 percent quality. Heat is now transferred to the refrigerant until the pressure reaches 700 kPa. Determine (a) the mass of the refrigerant in the tank and (b) the amount of heat..

Battery of silicon photocells mounted on plane surface : A battery of silicon photocells mounted on a plane surface operates with an efficiency of 16.7% under all conditions encountered in this problem. it is installed at a location 45 degrees north. the time is 10:00 on April 1, 1995. When the battery fac..

Assume ideal gas behavior with constant specific heats : The following cycle involves 3 kg of air. From 1 to 2 is polytropic compression where P1=150 kPa, T1=360 K, P2=750 kPa, V2=0.54 m^3 and n=1.2 . From 2 to 3 is constant pressure cooling and from 3 to 1 is constant temperature heating. Determine the to..

Compute the frictional losses between these two sections : Water flows in a 2 ft diameter duct under the following conditions: p1= 55 psia and v1=20ft/sec. At another section 12 ft below the first the diameter is 1 ft and the pressure p2=40 psia. Compute the frictional losses between these two sections. Dete..

User Account

All Pages