Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A rigid tank has a volume of 23.3 m3 and due to safety requirements its pressure should not exceed 105 bar. If the tank has been filled with 1000kg of water vapor and is heated to 360°C check to see if it is within safety requirements.
Using:
a) The Van der Waals equation
b) The Redlich-Kwong equation
c) The compressibility chart
a square aluminum plate 5 mm thick and 200 mm on a side is heated while vertically suspended in quiescent air at 40c. a
an aluminum plate 0.5 cm thick is to withstand a force of 50000 n with no permanent deformation. if the aluminum has a
a fan drawing electricity at a rate of 1.5 kw is located in a room measuring 10 ft times 13 ft times 16 ft. the air in
an insulated piston-cylinder device contains 5l of saturated liquid water at a constant pressure of 175kpa. water is
a cast-iron stream pipe of 0.11m od. and 0.10m ud carries stream at 200acircdegc. it is to be insulated with a 0.025m
Verify that heating the wire may be treated as a lumped-capacity process, find the steady-state temperature of the wire and find how long it takes for the temperature of the wire to reach 100°C.
a diesel engine uses 54.4 kg of fuel oilh of calorific value 45 mjkg. the thermal efficiency of the engine is 25.
an overhead 30-m-long uninsulated industrial steam pipe of 120-mm diameter is routed through a buidling whose walls and
a 40 foot long aluminum street lighting support is sized and welded into position between two very large bridge beams
A piston-cylinder assembly contains Ammonia initially at a pressure p = 500 kPa and specific volume v = 0.24533 m^3/kg (state 1). Expansion occurs to a state where the pressure is 150 kPa (state 2). During the process the pressure and specific volume..
the compression ratio of an air-standard ideal otto cycle is 10. prior to the isentropic compression process the air is
when drilling a hole in a table leg a furniture maker uses a hand-operated drill with a bit of diameter d4.0mm.a. if
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd