The two purposes of amplification for digital systems

Assignment Help Mechanical Engineering

Reference no: EM13701667

The two purposes of amplification for digital systems are (i) to improve signal-to-noise ratio and (ii) to make good use of the dynamic range of the digitizer; in other words, to ensure the best resolution possible.

(i) The NI 9229 digitizing module is a 24 bit system. Express this value in terms of counts and the dynamic range terms of decibels. Show your derivations and calculations.

(ii) Consider a signal of 10 mV with a noise level of 0.1 mV. The signal is amplified 500 times. Determine the SNR in terms of decibels. Show your derivations and calculations.

(iii) For this 24-bit, 0–10 V digitizer, express a 4 mV signal in terms of counts. Show your derivations and calculations.

Reference no: EM13701667

Questions Cloud

Hydrostatics and stability-lightship condition : Hydrostatics and stability-In lightship condition, how does the ship trim and why? How does the ship react when weights are added or subtracted? How does the curve of statical stability change with vertical shift of weights?

Determine the systems thermal efficiency : Air enters a three-stage gas turbine at 100 kPa and 17 degree Celsius. This system uses a regenerator as well as reheating and inters cooling. The pressure ratio across each compressor is 14.16 (this is 14.16, NOT 14 and 16!); 300 kJ/kg of heat are a..

Domestic hot water supply : Steam at 500 kPa, 300 degrees C is used to heat cold water at 15 degrees C to 75 C for a domestic hot water supply. How much steam per kilogram of liquid water is needed if the steam should not condense?

Determine the response of the measurement system : A measurement system can be modelled by the equation given below, (5/8)y' +y=F(t). The output signal is initially steady at 5 V. The input signal is then suddenly increased to 8 V. Determine the response of the measurement system.

The two purposes of amplification for digital systems : The two purposes of amplification for digital systems are (i) to improve signal-to-noise ratio and (ii) to make good use of the dynamic range of the digitizer; in other words, to ensure the best resolution possible.

What is the gain required to make the digital resolution : The voltage output from a 0–50 psi pressure transducer will vary from 0–5 mV. The input/output relationship is linear. The signal will be recorded with a 12-bit A/D converter with a 0-10 V input range. The voltage output needs to be amplified before ..

Calculate drag force on flat bottom boat : Calculate drag force on flat bottom boat. What power is required to keep the boat moving at 0.5 m/s?

Find the power output in mw and the thermal efficiency : Consider a 2500 psia/1000 F turbine inlet, single reheat to 1000 F cycle with a reheat pressure ratio of P2/P1= 0.2 and a steam mass flow rate of 2 x 10^6 ibm/hr. The condensor operates at a pressure of 1 psia. Pump and turbine isentropic efficiencie..

Heat transfer involved in process closed system-ideal gas : 1 kg water in a piston cylinder device is initially at 250 degrees C and 300kpa (state 1) a total of 700 kj of work is done on the water in order to isothermally reduce its volume to 1/20 of its initial volume (state 2) determine the magnitude and th..

User Account

All Pages