The turbine operates without internal irreversibilities

Assignment Help Mechanical Engineering
Reference no: EM13719119

Steam at 550 lbf/in.2 , 700 o F enters a turbine operating at steady state and exits at 1 lbf/in.2 . The turbine produces 500 hp. For the turbine, heat transfer is negligible as are kinetic and potential energy effects.

a) Determine the quality of the steam at the turbine exit, the mass flow rate, in lb/s, and the entropy production rate, in Btu/s.oR, if the turbine operates without internal irreversibilities.

b) Plot the mass flow rate, in lb/s, and the entropy production rate, in Btu/s.oR, for exit qualities ranging from the value calculated in part (a) to 1.

Reference no: EM13719119

Questions Cloud

What are the bound surface charge densities : A very long, straight cylindrical conductor with radius R and length L carries a uniformly distributed net charge Q. What are the bound surface charge densities at r = 2R and at r = 4R
Determine the wavelengths of the observed spectral lines : In a Franck-Hertz type of experiment, atomic hydrogen is bombarded with electrons and excitation potentials are found at 10.21 V and 12.10 V. determine the wavelengths of the observed spectral lines
What is the ball impact speed on the ground below : A cannon tilted up at a 33 degree angle fires a cannon ball at 64.0 m/s from atop a 26 meter high fortress wall. What is the ball's impact speed on the ground below
Calculate what is the maximum speed : A block of mass 1.3 kg is attached to a horizontal spring that has a force constant 1200 N/m, What is the maximum speed
The turbine operates without internal irreversibilities : Steam at 550 lbf/in.2 , 700 o F enters a turbine operating at steady state and exits at 1 lbf/in.2 . The turbine produces 500 hp. For the turbine, heat transfer is negligible as are kinetic and potential energy effects.
Compute the output response of the system : Find H[k], the 10 point DFT of h[n] and compute the output response of the system y[n], 0 ≤ n ≤ 4, using the convolution sum.
What is the radius of the solenoid : An inductor in the form of a solenoid contains 400 turns and is 12.4 cm in length. What is the radius of the solenoid
The change in specific entropy between the specified states : Determine the change in specific entropy between the specified states, in kJ/kg·K. Water, p1 =10MPa, T1 =400°C,p2 =10MPa, T2 =100°C. Air asanidealgas,p1 =200kPa, T1 =7°C,p2 =100kPa, T2 =327°C.
Compute what upward force must a branch provide : Gibbons, small Asiam apes, move by brachiation, swinging below a handhold to move forward to the next handhold. What upward force must a branch provide to support the swinging gibbon

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The controlled variable in a closed-loop system is a robot

the controlled variable in a closed-loop system is a robot arm. initially it is at 45 degrees then it is commanded to

  The temperature reaches 1800 k at the end of the combustion

a diesel engine has a compression ratio of 20 and a cutoff ratio of 2. air is at 95 kpa and 290 k at the beginning of

  Water at 50kpa and 150 deg celsius enters a constant-area

water at 50kpa and 150 deg celsius enters a constant-area pipe a0.08m2 with a velocity of 11ms. at some point farther

  Compute the maximum contact pressure and the width of

two mating spur gears are 20 mm wide and the tooth profiles have radii of curvature at the line oif contact of 10 and

  A component is fully constrained with 0 dof

An engineer insists that a component is fully constrained with 0 DOF because 2 plates are bolted together with 4 screws (assuming one of the 2 plates is considered "grounded"). Is he / she correct? Explain why or why not using concepts discuss..

  Determine the thermal efficiency of a carnot cycle operating

An ideal Otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 540R and 2400R.

  Elapse until the rate of filtration drops

A liquid is filtered at pressure of 200 kPa through a 0.2 m2 filter. Initial results indicate that 5 minutes is required to filter 0.3 m3 of liquid. Determine the time that will elapse until the rate of filtration drops to 5 * 10-5 m3 s-1. The filter..

  Air enters the duct of an air-conditioning system at 15

air enters the duct of an air-conditioning system at 15 psia and 50f at a volume flow rate of 450 ft3min. the diameter

  A bullet of mass 006 kg is fired horizontally into a wooden

a bullet of mass 0.06 kg is fired horizontally into a wooden block of mass 0.10 kg. the wooden block is suspended from

  Calculate the magnitude of the total acceleration of her

danica traveling at a speed of 200 kmhr on a straight road applies brakes to her car at point a and reduces her speed

  A steam turbine operates with 16 mpa and 350 degree c

a steam turbine operates with 1.6 mpa and 350 degree c steam at its inlet and saturated vapor at 30 degree c at its

  Determine the state of the ammonia after the throttling

water and ammonia streams flow through a steady state heat exchanger. the water stream enters the heat exchanger with a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd