The total heat transfer rate from the plate to the air

Assignment Help Mechanical Engineering
Reference no: EM13719872

Air at 40C flows over a 2m long flat plate with a free stream velocity of 7 m/s. Assume the width of the plate (into the paper) is 0.5m. If the plate is at constant temperature of 100C, find:

1) The total heat transfer rate from the plate to the air.

2) The local heat flux at the midpoint of the plate's length.

Reference no: EM13719872

Questions Cloud

Vapor compression refrigeration cycle : A vapor compression refrigeration cycle has a theoretical COP of 4.8 and provides 120,000 btu/h of cooling (same as 10 tons of cooling). The compressor is driven by a motor with an efficiency of 92%. Estimate the theoretical kW electrical demand that..
Dam is to be built such that the estimated average flow : The dam is to be built such that the estimated average flow over its crest will be Q = 3000 m^3/s. Determine the required flow over the crest of a model built to a scale of 1/25
What is the entropy generation in the process : A thermodynamicist is attempting to model the process of balloon inflation by assuming that the elastic casing behaves like a spring opposing the expansion as presented in the figure. As air is admitted, the spring is compressed.
Dissipates heat by free convection : A thin long electric heater of width 20 cm is placed with its width oriented vertically. It dissipates heat by free convection from both sides of its surface into air at 20C. If the heater should not exceed 225C, determine the length of the heater in..
The total heat transfer rate from the plate to the air : Air at 40C flows over a 2m long flat plate with a free stream velocity of 7 m/s. Assume the width of the plate (into the paper) is 0.5m. If the plate is at constant temperature of 100C,
Air undergoes an isentropic process : Air undergoes an isentropic process from P_1 = 100 kPA and T_1 = 300 K to a final state where the temperature is 700 K. Assuming an ideal gas, find P_2 in kPa using both the ideal gas tables and assuming a constant specific heat ratio at the average ..
What could be done to limit or deny these lawsuits : In the prison system of today, inmates are overburdening the courts with lawsuits. What could be done to limit or deny these lawsuits?
Explain the development of prisons used criminal offenders : Before the development of prisons, physical punishments were commonly used on criminal offenders. Discuss if corporal punishments would again serve a purpose in dealing with some of today's offenders. Give examples
Generate a web page that uses a description list : Create a web page that uses a description list to display three network protocols and their descriptions. Include a hyperlink to a website that provides information about the protocols.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What is the input current and the voltage across the output

consider the following pulse width modulation rc circuit. the circuit consists of a switch two resistors and a

  What is the potential difference across each capacitor

Capacitors C1=12micro Farad and C2=28microFarad are each charged to 15V , then disconnected from the battery without changing the charge on the capacitor plates. The two capacitors are then connected in parallel, with the positive plate of C1 connect..

  Review the logic used to develop brake systems

Analyse the operational characteristics of the current system / component available in the market and future systems yet to come into production. Analyse the effect of the system on the environment and its sustainability.

  For operation at steady state determine the maximum

according to test data a new type of engine takes in streams of water at 400 degrees f 40 psia and 200 degrees f 40

  The displacement vectors 460 cm at 150deg and 230 cm at

the displacement vectors 46.0 cm at 15.0deg and 23.0 cm at 56.0deg both start from the origin and form two sides of a

  If the cooling water enters at a temperature of 20 degree c

one way to decrease the power needed to compress a gas using a compressor is to encompass the compressor in a water

  A locomotive car of mass 2000 kg traveling at a velocity

a locomotive car of mass 2000 kg traveling at a velocity v10msec is stopped at the end of tracks by a spring-damper

  Four weights is to pass through the center of the raft

Three children are standing on a 5×5-m raft. The weights of the children at Points A, B, and C are 375 N, 260 N, and 400 N, respectively. If a fourth child of weight 425 N climbs onto the raft, determine where she should stand if the other children r..

  Te position of a crate sliding down a ramp is given by x

the position of a crate sliding down a ramp is given by x 0.25t3 y1.5t2 z6-0.75t2.5 all in units of m where t is in

  Determine the reading on the pressure gage in psig when all

a transparent rigid container is filled with 2 gallons of water. initially the pressure is measured to be 10.2 psig

  The valve connecting the tanks is opened and the gas

two tanks containing air are connected via a valve. the first tank is 0.5 m3 and contains air at t 25 oc and p 500

  Explain square steel bar subjected to transverse biaxial

Consider a 4-in square steel bar subjected to transverse biaxial tensile stresses of 20 ksi in the x direction and 10 ksi in the y direction.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd