The steam line leading to the turbine inle

Assignment Help Mechanical Engineering
Reference no: EM13520433

To control the power output of an isentropic steam turbine a throttle valve is placed in the steam line leading to the turbine inlet. steam at 6 MPa and 700c is supplied to the throttle inlet.and the turbine exhaust pressure is set at 70 kPa. what is the effect on the stream exergy at the turbine inlet when the throttle valve is partially closed such that the pressure at the turbin inlet is 3 MPa.compare the second-law efficiency of this system when the valve is partially open to when it is fully open.take t=25 c

Reference no: EM13520433

Questions Cloud

What are the differences between urgent care centers : What are the differences between Urgent Care Centers and Emergency departments?
Calculate the power factor at this frequency : An AC voltage with an amplitude of 129 V is applied to a series combination of a 163 ?F capacitor, a 121 mH inductor, and a 21.9 ? resistor. Calculate the power factor at this frequency
Find its velocity as a function of time : A metal wire of mass m can slide without friction on two parallel, horizontal, conducting rails. find its velocity as a function of time
Find how far from the earths center is it : If a projectile is launched vertically from the Earth with a speed equal to the escape speed, how far from the Earth's center is it when its speed is 1/6 of the escape speed
The steam line leading to the turbine inle : The steam line leading to the turbine inle
Shortest form in the declaration of independence : Can you show how Jefferson's theory of revolution (found in its shortest form in the Declaration of Independence) follows from John Locke's theory of government? Could it follow from Hobbes's theory of government? Under what circumstances?
It is within safety requirements : A rigid tank has a volume of 23.3 m^3 and due to safety requirements its pressure should not exceed 105 bar. If the tank has been filled with 1000kg of water vapor and is heated to 360°C check to see if it is within safety requirements.
Find how many kilocalories did the food make available : A 22 g dried sample of food is placed in an aluminum bomb calorimeter and burned completely. The device consists of an aluminum chamber (0.50 kg) containing the sample, how many kilocalories did the food make available
Find the number of millimeters by which the ice thickens : A 0.27-m-thick sheet of ice covers a lake. The air temperature at the ice surface is -10°C. In five minutes, the ice thickens by a small amount. Find the number of millimeters by which the ice thickens

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The airbus a-340 passenger plane has a maximum takeoff

the airbus a-340 passenger plane has a maximum takeoff weight of about 260000 kg a length of 64 m a wing span of 60 m a

  What is the k.e. of the satellite

A satellite has been placed in a circular, sun-synchronous orbit at an altitude of 1300.0 km. The satellite has a mass of 5,000.0 kg. What is the K.E. of the satellite?

  The Case for Global Accounting Standards

The role of IFRS in both developing and developed capital markets.

  Determine the required power input to the compressor

Air at the rate of 18 kg/s is drawn into the compressor of a jet engine at 55 kPa and -23oC and is compressed reversibly and adiabatically to 276 kPa. Determine the required power input to the compressor expressed in horsepower.

  Find the natural frequency of a pendulum for small angle

find the natural frequency of a pendulum for small angle deflections when the mass of the rod/string is not negligible. (Mass of rod = m, mass of ball = M.

  What is the nature of the process fluid

What is the nature of the process fluid and what are the objectives of the two sample points and in what way do the samples reaching the instruments differ?

  Why cooling strategies different in these two applications

Lawn mower engines normally have finned surfaces directly attached to the engine block, with no radiator, in order to achieve the required cooling. Why might the cooling strategies be different in these two applications?

  Finite element analysis fea is a modern-day tool in the

finite element analysis fea is a modern-day tool in the analysis of structural mechanics fluid dynamics and heat

  Determine temperature at which the water starts boiling

A cooking pan whose inner diameter is 20 cm is filled with water and covered with a 4-kg lid. If the local atmospheric pressure is 101 kPa, determine the temperature at which the water starts boiling when it is heated.

  A uniform rod ab of length 3m and mass 20kg is suspended

a uniform rod ab of length 3m and mass 20kg is suspended with its end b against a vertical wall while its end a is

  Estimate the uncertainty in indicated speed

An auto speedometer is graduated in 5 mph increments and has an accuracy rated to be within ±4%. Estimate the uncertainty in indicated speed at 60 mph.

  Why does the definition of npsh include the dynamic head

Why does the definition of NPSH include the dynamic head of the fluid? Isn't cavitation based only on the difference between the static head and the local vapor pressure?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd