The pipe entrance is flush and square edged

Reference no: EM13548169

Water flows through 800 feet of 12-inch diameter iron pipe (? = 0.0018 inches) between 2 open storage tanks, whose water surface elevation difference is 16 feet. The pipe entrance is flush and square edged, and there is a swing check valve and 2- 45° bends in the line. What is the flow rate?

a).1000 GPM

b).2800 GPM

c).4300 GPM

d).6700 GPM

Reference no: EM13548169

Questions Cloud

Write a vba function that receives a gauge pressure : A 50-m tape is used to measure between two points. The average weight of the tape per meter is 0.320 N. If the measured distance is 48.888 m, with the tape supported at the ends only and with a tension of 100 N, Find the corrected distance.

What horsepower must be supplied to the pump in order : A pump of 80% efficiency lifts water from one large open tank to another; the difference in water surface elevations is 20 feet. The pipe is relatively smooth (f = 0.0122), and has 3 elbows, each with a loss coefficient of 2/3.

Determine the prism constant : To verify the constant of a particular prism, a straight line EFG is laid out. The EDM instrument is first set up at E, with the following measurements recorded: EG = 426.224 m, EF = 277.301 m

Compute the required layout distance if the temperature : A distance of 72.55 ft is recorded using a steel tape weighing 0.016 lb per foot. The tapes is supported only at the ends with a tension of 15 lb. Find the distance corrected for sag.

The pipe entrance is flush and square edged : Water flows through 800 feet of 12-inch diameter iron pipe (? = 0.0018 inches) between 2 open storage tanks, whose water surface elevation difference is 16 feet. The pipe entrance is flush and square edged

Determine the force in each member : The truss shown consists of 9 members and is supported by a ball and socket at A, two short links at B, and one short link at G. Check that this truss is a simple truss, that it is completely constrained

Determine the coefficient of statics friction between : A hawser is wrapped two full times around a bollard. by exerting an 80 pound force on the free end of the hawser a dockworker can resist a force of 5000 on the other end of the hawser.

Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.

Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.

User Account

All Pages