The percent voids in the sand

Assignment Help Civil Engineering
Reference no: EM13900250

If a mortar is proportioned to 0.11 ft3 of cement, 0,03 ft3 of lime, 0.27 ft3 of water, and 0.50 ft3 of sand, the percent voids in the sand is? (Assume a sand Bulk Specific Gravity Oven-dry of 2.60; of cement 3.15, and lime 2.25 if needed).

Answer choices:

a. 0.0%

b. 1.0%

c. 50.0%

d. 8.0 %

e. None of the above.

Reference no: EM13900250

Questions Cloud

Is this a representative sample mean or an extreme value : A random sample is obtained from a normal popula- tion with a mean of m 5 95 and a standard deviation of s 5 40. The sample mean is M 5 86. Is this a representative sample mean or an extreme value for a sample of n 5 16 scores?
What is the local molar flux at the disc surface : The disc is made of a sparingly soluble solute A that slowly dissolves in the flowing solvent B. What is the local molar flux at the disc surface
The 50-lb block a and the 25-lb block b : The 50-lb block A and the 25-lb block B are supported by an incline that is held in the position shown. Knowing that the coefficient of static friction is 0.20 between the two blocks and zero between block B and the incline, determine the value of θ ..
Discuss whether lee garrett was acting in an ethical manner : Discuss whether Lee Garrett was acting in an ethical manner. How might Guardsman Security Co. use internal controls to prevent this scenario from occurring?
The percent voids in the sand : If a mortar is proportioned to 0.11 ft3 of cement, 0,03 ft3 of lime, 0.27 ft3 of water, and 0.50 ft3 of sand, the percent voids in the sand is? (Assume a sand Bulk Specific Gravity Oven-dry of 2.60; of cement 3.15, and lime 2.25 if needed).
The advantages of using precast floor slab half : The advantages of using precast floor slab half is:A. Reducing the volume of concrete
Give atleast three methods : Give atleast three methods that can be use to analyse structures
Problems were found in the use of precast concrete : Problems were found in the use of precast concrete, is:A. Need a larger initial investmentB. Requires fabricating a very wide area
Determine ratio of cash to monthly expenses as of december : Determine the ratio of cash to monthly expenses as of December 31, 2004, 2003, and 2002. Round to one decimal place. Based upon (1) and (2), comment on OccuLogix's ratio of cash to monthly operating expenses for 2004, 2003, and 2002.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the variation of the peak soil friction angle

This Table gives the standard penetration numbers determined from a sandy soil deposit in the field. Depth (m) 3.0, 4.5, 6.0, 7.5, 9.0, 10.5, 12. Unit weight of soil Kn/M^3

  How the gravel will be scoured by the flowing water

The trapezoidal channel has a slope of .004. The sides of the canal are sealed with a plastic membrane, which is protected by a 1 ft thick layer of 1 in diameter gravel. The bottom is a 6 in slab of rough concrete.

  Explain why the boss is concerned for the materials

A young engineer is asked to design a thermal protection barrierfor a sensitive electronic device that might be exposed toirradiation from a high-powered infared laser.

  Calculate the vertical stress at a depth of 4m vertically

Three point loads 10,000, 7500 and 9000 kN act in line 5m apart near the surface of a soil mass. Calculate the vertical stress at a depth of 4m vertically below the centre (7500kN) load.

  Determine the depth of flow immediately upstream of the hump

A rectangular channel of 2 m depth and 5 m width carries 1 m deep running water. It is laid to a slope of 0.001 with Manning's n = 0.02. Some distance downstream there is a hump of height 0.5 m on the stream bed.

  What is the manometer reading at b

A venturi meter is used to measure flow velocity. Given the manometer reading at A is 100 kPa, D = 10 cm, d = 5 cm, VA = 2 m/s, and specific weight of water is 9800 N/m3.

  Find the rate of discharge of water at 60 degrees fahreneit

Three new cast iron pipes, having diameters of 24, 21 and 18 in respectively, each 450-ft long, are connected in series. The 24-in pipe leads from a reservoir (flush entrance), and the 18-in pipe discharges into the air at a point 15 ft lower than th..

  Calculate primary consolidation settlement for the ch layer

Calculate the primary consolidation settlement for the CH layer, assuming that it is normally consolidated with a water content of 70% and a compression index of 0.25.

  Determine the density of the air

Some experiments are being conducted in a laboratory in which theair temperature is 26o C and the atmosphericpressure is 14.6 psia. Determine the density of the air.Express your answers in slugs/ft3 andkg/m3.

  What is the waters temperature at the exit of the turbine

A turbine operates at steady state with steam flowing through it at a rate of 36 kg/min. The steam enters the turbine at a temperature of 600C and a pressure of 8 MPa and exits at a pressure 90% lower with a quality of 70%.

  Find coefficient of kinetic friction if car comes to stop

A classic car is d riving down an incline at 60 km / h when its brakes are applied. Treating the car as a particle, neglecting all forces except gravity and friction, and assuming that the tires slip

  Probability of the functions of car battery

The probability that a new car battery functions for over 10,000 miles is .8, the probability that it functions for over 20,000 miles is .4, and the probability that it functions over 30,000 miles is .1. If a new battery is still working after 10,..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd