The end of the bar will be in contact with the frame

Assignment Help Mechanical Engineering

Reference no: EM13702469

A 250mm long brass bar (CTE = 20.5X10-6 / 0 C) is being supported as shown below. Initially, when the temperature is 15 deg C, there is a total clearance of 0.25mm between the right end (left end is secured to the left side support) of the bar and the right side support. At what temperature, the end of the bar will be in contact with the frame? When temperature of the bar rises to 90 deg C, is there any stress developed in the bar? If yes, what is its magnitude?

Reference no: EM13702469

Questions Cloud

Determine relative humidity-humidity ratio and the enthalpy : Atmospheric air at a pressure of 1 atm and dry-bulb temperature of 90F has a wet bulb temp of 85F. Using the psychometric chart, determine (a) the relative humidity, (b) the humidity ratio, (c) the enthalpy, (d) the dew point temp and (e) the water v..

Refraction of a light beam at the interface of two media : The following is a diagram shows refraction of a light beam at the interface of two media. The incidence and refraction angles are measured to be 45 deg and 30 deg respectively. Will total reflection happen when the light beam shins from the top to t..

Calculate electric power input to oven per unit oven width : The electric reheating oven is used to heat a continuous sheet of metal from 25-1000C The metal speed is such that the strip of metal spends 2 hours inside this oven, The sheet thickness is 1cm and the ambient temperature is 25C with the temperature ..

District heating system should supply hot water : If the district heating system should supply hot water at 900C, what is the lowest possible condenser pressure with water as the working sub-stance?

The end of the bar will be in contact with the frame : A 250mm long brass bar (CTE = 20.5X10-6 / 0 C) is being supported as shown below. Initially, when the temperature is 15 deg C, there is a total clearance of 0.25mm between the right end (left end is secured to the left side support) of the bar and th..

Calculate the electric power input to the oven per unit : The electric reheating oven shown in the figure is used to heat a continuous sheet of metal from 25-1000C The metal speed is such that the strip of metal spends 2 hours inside this oven, The sheet thickness is 1cm and the ambient temperature is 25C w..

The beginning the channel is idle : An ad Hoc network using IEEE802.11 has 4 nodes: N1, N2, N3, N4. Assume that SIFS is 1 unit of time, PIFS 2 units of time, DIFS 3 units of time, and slot time is 2 (these values are not the real values but are taken to simplify the packets sched..

Find the fraction of extraction steam flow : A power plant with one closed FWH has a con- denser temperature of 450C, a maximum pressure of 5 MPa, and a boiler exit temperature of 900C. Extraction steam at 1 MPa to the FWH condenses and is pumped up to the 5-MPa feed water line, where all the w..

Global investment managers and index funds : Explain step by step the way to solve the question - Just to make sure that the work will not include the Global Investment Managers (GIM) and Index funds UK (IFU) from the file.

User Account

All Pages