User Account

All Pages

The electrical power input to the pump transporting the

Assignment Help Mechanical Engineering
Reference no: EM13630583

Liquid methanol is pumped from a large storage tank through a 1.256 inch ID pipe at a rate of 3.00gal/min.

(a) At what rate in (i) ft x lbt/s and (ii) hp is kinetic energy being transported by the methanol in the pipe?

(b) The electrical power input to the pump transporting the menthol must be greater than the amount you calculated in part (a). What would you guess becomes of the additional energy? (There are several possible answers)

Reference no: EM13630583

Questions Cloud

Steam enters a nozzle operating at steady state at 20 bar : steam enters a nozzle operating at steady state at 20 bar temperature 280c with a velocity of 80 ms. the exit pressure
Calculate the mass of different cementites that form upon : calculate the mass of different cementites that form upon cooling from the liquidus temperature to the room temperature
The specifications for an automobile fuel pump state that : the specifications for an automobile fuel pump state that it should pump 1 l of gasoline in 40 seconds with a suction
A convergent lens has a focal length of 7cm a 2cm tall : a convergent lens has a focal length of 7cm. a 2cm tall image forms 30cm from the lens.a how far is the magnification?b
The electrical power input to the pump transporting the : liquid methanol is pumped from a large storage tank through a 1.256 inch id pipe at a rate of 3.00galmin.a at what rate
The speed of light in a material is 050 c what is the : 1 the speed of light in a material is 0.50 c. what is the critical angle of a light ray at the interface between the
Saturated water vapor at 200 kpa is expanded slowly and : saturated water vapor at 200 kpa is expanded slowly and without friction i.e. internally reversibly and isothermally in
A special high pressure u-tube manometer is constructed to : a special high pressure u-tube manometer is constructed to measure pressure differential in air at 13.8mpa and 20 c
The steam enters at 25 bar with a velocity of 61 ms and : a well-insulated turbine operating at steady state develops 28.75 mw of power for a steam flow rate of 50 kgs. the

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the mass of neon gas in si units

A volume of 1.8 L of neon gas (monatomic) is at a pressure of 3.4 atmospheres and a temperature of 370 K. The atomic mass of neon is 20.2 g / mol. Calculate the mass of neon gas in SI units.

  For each case determine the specified property value and

for each case determine the specified property value and locate the state by hand on sketches of the p-v and t-v

  What is the maximum possible temperature of the high

a refrigerator cycle has a cop of 3 and removes 100kw of heat from a building which is kept at 23c. the device rejects

  Determine the nozzle diameter for the second case assuming

a fire hose needs to deliver 25 ls of water to a maximum height of 50 m above ground level. a find the stagnation

  The bases of the boxes in contact with the floor have

two boxes made of the same material have the same masses but their dimensions are different. the bases of the boxes in

  Using the same power found in the part a above what would

a heat pump will be used to heat a building during the winter and will then cool the same space during the summer. the

  Determine the maximum theoretical power that can be

steam at mpa 500 degrees c enters an insulted turbine operating at steady state with a mass flow rate of 7 kgs and

  What would be the natural period of the system

If an identical spring is cut so that one part is one-fourth and the other part three-fourths of the original length, and the mass m is connected to the two parts, what would be the natural period of the system?

  A rigid 12m3 tank contains water at pressure of 1985 with

a rigid 1.2m3 tank contains water at pressure of 198.5 with 10 percent liquid and 90 percent vapor by volume. a

  Features are used to assess quality

Assume the same eight features are used to assess quality

  At what temperature does the first liquid phase form

What is the composition of the last solid remaining prior to complete melting?

  Based on your knowledge of force-deformation properties of

juice is extracted from fruits such as apples by compressing and crushing them. based on your knowledge of

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd