The amplitude of this signal

Assignment Help Electrical Engineering
Reference no: EM13993875

Question 1. 1. (TCO 1) The signal is 5 sin (2 pi 2000 t + 60 degrees). The amplitude of this signal is
       5 VPP
       3.535 VPP
       3.535 VRMS
       3.535 VPK

Question 2. 2. (TCO 1) The signal is 10 sin (2 pi 1000 t + 30 degrees). The frequency of this signal is
       2000 Hz
       1000 Hz
       6280 Hz
       10 kHz
Question 3. 3. (TCO 1) The signal is 10 sin (2 pi 1000 t + 30 degrees). The phase shift of this signal is
       +60 degrees
       +30 degrees
       -30 degrees
       -90 degrees
Question 4. 4. (TCO 1) The signal is 10 sin (2 pi 1000 t + 30 degrees). The voltage displayed on the DMM is
       10 V PP
       7.07 V PP
       7.07 VRMS
       10 VPK
Question 5. 5. (TCO 1) Capacitive reactance XC is
       inversely related to only frequency.
       inversely related to only inductance.
       inversely related to the product of [2 , times the capacitance C and frequency f].
       No correct answer listed
Question 6. 6. (TCO 2) In an AC circuit with reactance XC in series with a resistor the circuit current
       leads the applied voltage.
       lags the applied voltage.
       voltage and the current are in phase.
       No correct answer is listed
Question 7. 7. (TCO 2) For the following series AC circuit, the angle of the circuit impedance is
       0 degrees
       +90 degrees
       +45 degrees
       -45 degrees
Question 8. 8. (TCO 2) For the following series AC circuit, the phase angle of the circuit current is

 

       0 degrees
       +90 degrees
       +45 degrees
       -45 degrees
Question 9. 9. (TCO 2) For the following series AC circuit, the total circuit impedance is:
       100 + j 100 
       100 - j 100 
       100 - j 200 
       100 + j 300 
Question 10. 10. (TCO 3) For the parallel AC circuit shown below, find the circuit current IS . Note that Vin AC is mislabeled, it should be 10V, NOT 10 sin(ω t).
       0.1 + j 0.1 A
       0.1 - j 0.1 A
       0.1 A
       j 0.1 A
Question 11. 11. (TCO 3) The total admittance for the following circuit is
Hint: YT = G + j (BC - BL) siemens; G = 1/R siemens; BC = C siemens and BL = 1/[ L ] Siemens
       0.005 - j 0.015 siemens
       0.005 + j 0.015 siemens
       0.01 - j 0.005 siemens
       0.01 + j 0.005 siemens
Question 1. 1. (TCO 4) Determine the resonance frequency of the following circuit to the nearest integer value.
       563 Hz
       1125 Hz
       281 Hz
       1000 Hz
Question 2. 2. (TCO 4) We need to purchase an inductor coil for a resonance circuit resonating at 1500 kHz; the operating bandwidth is 10 kHz. What is the quality factor Q of the coil?
       150
       30
       10
       1500

Question 3. 3. (TCO 5) The Thevenin's theorem is used
       to calculate the open circuit voltage at the output of a circuit.
       to analyze any circuit with multiple sources using one at a time.
       to calculate the short circuit current at the output of a circuit.
       to calculate the open circuit current at the input of a circuit.
Question 4. 4. (TCO 6) In an audio system we need to feed the audio signal to a woofer (a low frequency speaker). This can be accomplished by using a ______.
       band pass filter
       low pass filter
       high pass filter
       band stop filter

Question 5. 5. (TCO 6) The cut off frequency is also known as the ______.
       resonance frequency
       full power point
       3 dB point
       unity gain point

Question 6. 6. (TCO 7) We need to bring down the voltage from 1200 V to 120 V. The transformer turns ratio is ______.
       1:10
       1:100
       10:1
       5:1

Question 7. 7. (TCO 7) To convert from AC to DC using a center tap transformer, we need to use ___ diodes.
       1
       3
       2
       4

Question 8. 8. (TCO 1) The significance of RMS in reference to a sine wave is _______.        
      

Question 9. 9. (TCO 2) How do you find the total reactance of multiple capacitive reactances connected in series?       
      
 
Question 1. 1. (TCO 3) What is the phase angle of a capacitive susceptance?      
      

Question 2. 2. (TCO 4) For a given tank circuit resonance frequency, what is the parameter that determines the bandwidth?      
      
Question 3. 3. (TCO 5) If we need to obtain the open circuit voltage and an equivalent impedance at the circuit load terminals which circuit theorem comes handy? 

Question 4. 4. (TCO 6) A low pass filter has a cut-off frequency of 5 kHz and a high pass filter has a cut-off frequency of 8 kHz. These two circuits are connected back to back in cascade to form an input-output system. How does this combination work, band pass or band stop?   

Reference no: EM13993875

Questions Cloud

What is the wacc before the change in capital structure : Find the intrinsic value of the firm after the change and what could be the intrinsic stock price, which can translate to the market stock price.
The signal cos(2pt) is of course periodic : The signal cos(2πt) is of course periodic .What is the period ?
Determine the reactions at points b and e : At point E, the tip of the tonearm rests on the lightly grooved surface of a vinyl record. If the tonearm weighs 0.2 lb with a center of gravity at point G, and the force P=.01 lb acts in the x direction, determine the reactions at points B and E...
Magnitude of the impalse delievered to the rubber ball : The magnitude of the impalse delievered to the rubber ball by the floor is greater, less or equal to that delievered to the clay ball by the floor?
The amplitude of this signal : Question 1. 1. (TCO 1) The signal is 5 sin (2 pi 2000 t + 60 degrees). The amplitude of this signal is        5 VPP        3.535 VPP        3.535 VRMS
What are the pros and cons for each method : If you found a movies clip about it write a paragraph in your own words to describe what it shows, include a link to the clip. Describe two existing numerical methods to solve Maxwells-equation, what are the pros and cons for each method.
What is its electric potential energy : In a classic model, the electron of a hydrogen atom circles the proton at a radius of 1.3225x 10-9 m when it is in the n=5 state. What is its electric potential energy?
Explain how you could go about resolving the stalemate : Everyone has valid points to make, but the team is getting bogged down in conflict. Explain how you could go about resolving the stalemate.
What are reasons for the firm to go abroad : Five years ago, Jane invested $5,000 and locked in an 8 percent annual interest rate for 25 years (ending 20 years from now). James can make a 20-year investment today and lock in a 10 percent interest rate. How much money should he invest now in ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd