Temperature drop during this process-final specific volume

Assignment Help Mechanical Engineering
Reference no: EM13711580

Refrigerant-134a is throttled from saturated liquid state at 7 bar to a pressure of 1.4 bar. Determine the temperature drop during this process and the final specific volume.

Reference no: EM13711580

Questions Cloud

Streams of cold and warm air are mixed to get air : In air-conditioning systems, streams of cold and warm air are mixed to get air with the right temperature. Consider a mixing chamber into which cold air enters at 8C and 100 kPa at a rate of 0.55 m^3 /s and warm air enters at 300C and 100 kPa.
Show that the total energy of a circular membrane : Show that the total energy of a circular membrane when vibrating in its fundamental mode is given by 0.135(?a^2)?_s (?A_1 )^2, where a is its radius, ?_s the area density, ? the angular frequency of vibration, and A_1 the amplitude at its center.
Discuss the different types of energies : Discuss the different types of energies that could be used to supply homes and industry. What are the advantages and disadvantages of each? Of these choices, which on e you feel is the best choice and should be better utilized. Discuss your cho..
Steam with a mass flow rate : Steam with a mass flow rate of 200,000 lb/hr enters a well insulated turbine at 1100 psi, 900degreeF through a duct with a flow area of 1ft^2. A portion of the steam is extracted at p=130psi,T=380degreeF and exits through a 1 ft diameter duct at v=60..
Temperature drop during this process-final specific volume : Refrigerant-134a is throttled from saturated liquid state at 7 bar to a pressure of 1.4 bar. Determine the temperature drop during this process and the final specific volume.
Cauchys theorem for a triangle : The theorem stated below is followed by statements from its proof. For each of the numbered statements provide a short comment that explains or justifies it.
Steady flow operation and constant specific heat for water : A water fountain consume 24.1 amps (operating at 110 V) to chill water from 23 C to 5 C. It is known that heat is rejected from the unit at a rate of 9.5 kW. Assuming steady flow operation and constant specific heat for water (at 25 C)
Fraction of heat release at constant pressure conditions : A four cylinder, 3.6 litter CI engine operates with a compression ratio of 18 and an air fuel ratio of 17. The engine operates on a dual cycle. The maximum pressure is limited to 12MPa and the maximum temperature is limited to 3600 K. Assume that at ..
What is the air-fuel ratio : A fuel consisting of 20% ethanol and 80% isooctane on a molar basis is burned with air in an engine. Write the balanced chemical reaction when this reaction is stoichiometric. What is the air-fuel ratio?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the thermodynamic efficiency and back work ratio

A regenerative gas turbine is planned to operate with inlet conditions of 100 kPa and 300 K, a pressure ratio of 6, a turbine inlet temperature of 1600 K, and a net power output of 150 kW. The effectiveness of the regenerator is 90% and the adiabatic..

  If the increase in th or the decrease in tl is amp kelvin

a reversible carnot power cycle operates between reservoirs th and tl. to increase the thermal efficiency of the cycle

  Find the exit temperature of the air in degc find the

refrigerant-22 is condensed from 120degc 1.40 mpa to saturated liquid using air at 24degc 1.00 bar. the air absorbs

  Determine a suitable length for the bolt rounded up to the

a 1.5 inch thick steel plate and a 0.5 inch thick cast iron plate are compressed with 14- 20 unc grade 5 bolt and

  A truncated cone 20 cm high is constructed of aluminum the

a truncated cone 20 cm high is constructed of aluminum. the diameter at the top is 8 cm and the diameter at the bottom

  If the air undergoes an adiabatic expansion process through

air at 800 kpa and 400oc enters a steady-flow nozzle with a low velocity and leaves at 100 kpa. if the air undergoes an

  The maximum temperature is 1200 k and the minimum

a stationary gas turbine plant operates on the brayton cycle and delivers 20000 kw to an electric generator. the

  Assuming all processes are reversible determine the ratio

it is desired to produce refrigeration at -25f. a heat source is available at 500f and the ambient temperature is 80f.

  Shaft of a rolling machine is driven by means of a motor

The shaft of a rolling machine is driven by means of a motor placed horizontally. The flywheel which also acts as a pulley is of 1.5 m diameter and has belt tension 5.4 kn and 1.8 kn on tight and slack side respectively.

  If all transitions between these states and ground occurred

a nucleus has 4 excited states at 0.123 mev 0.216 mev 0.401 and 0.555 mev above the ground state. if all transitions

  Determine the functional realtionship between the maximum

closing a value suddenly in a pipe with flowing water can generate water hammer where the momentum of the water column

  Calculate the systematic error-random and precision error

The lift force on a Wortmann air foil is measured five times under the same experimental conditions. The acquired values are 10.5N, 9.4N, 9.1N, 11.3N, and 9.7N. Assuming the true lift force is 10.7N; calculate a) the systematic error, b) random error..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd