Taking the object and liquid as a system how much word the

Assignment Help Mechanical Engineering
Reference no: EM13626873

A 4 kg object traveling at 60 m/s, enters an insulated vat of 20 kg of incompressible fluid (C = 2.0 kJ/kgK) and comes to rest before hitting the bottom. Neglecting potential engergy, and taking the object and liquid as a system, how much word the Temperature of the liquid rise or fall? Assume the temperature of the object doesn not change.

Reference no: EM13626873

Questions Cloud

Seven persons are staying at a hotel the hotel has : seven persons are staying at a hotel. the hotel has twenty-five floors each with the same number of rooms. each of the
A study was conducted to measure the effectiveness of a : a study was conducted to measure the effectiveness of a hypnotism in reducing pain. the measurements are centimeters on
For the vapor power cycle steam enters the at 3 mpa and 500 : for the vapor power cycle steam enters the at 3 mpa and 500 c and leaves at 70 kpa and 200 c. the system is operating
The plates of a parallel-plate capacitor are 328mm apart : the plates of a parallel-plate capacitor are 3.28mm apart and each has an area of 12.2 cm2. each plate carries a charge
Taking the object and liquid as a system how much word the : a 4 kg object traveling at 60 ms enters an insulated vat of 20 kg of incompressible fluid c 2.0 kjkgk and comes to
Determine the manometer reading h for the manometer : air is drawn into a small open-circuit wing tunnel as shown. atmospheric pressure is 98.7 kpa abs and the temperature
Methane oxygen and nitrogen flow into an insulated tank the : methane oxygen and nitrogen flow into an insulated tank. the methane flow is 2 kgs at the 320k. the oxygen flow is 3
Use the power series method to solve the radial equation : the schrodinger equation of a two dimensional harmonic oscillator potential can be handled by separation of variables
A venture necked-down section in a pipe develops a low : a venture necked-down section in a pipe develops a low pressure that can aspire fluid upward from a reservoir. derive

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Plot lift and drag coefficient using matlab as a function

plot lift and drag coefficient using matlab as a function of angle of attack for a naca 2412 airfoil by using the

  What is the tension in the tow cable

the 3000 lb car and the 4600 lb tow truck are stationary. the muddy surface on which the car rest exerts a negligible friction force on the car. what is the tension in the tow cable.

  Water vapor initially at 30 mpa and 300degc is contained

water vapor initially at 3.0 mpa and 300degc is contained within a piston-cylinder. the water is cooled at constant

  Calculate the efficiency if a reheat loop was added at such

consider a steam plant operating on a rankine cycle with two open feed water heaters as shown in the figure. steam

  The water in the pool is 25 feet deep and the rim of the

a garden hose is open at one end and capped closed at the other. a swimmer in an above-ground pool fills the hose

  An engineer is designing a horizontal rectangular conduit

engineering fluid mechanics 9th editionauthors crowe elger williams roberson problem 9.62 pg 313.an engineer is

  Find the mass of liquid formed if the volume under the

saturated water vapor is enclosed in a piston cylinder arrangement with a volume v initial 5 liters at a temperature

  After a period of time the pressure in the tank rises to 15

initially an insulated rigid tank contains 3.73 kg of water at 240oc and 1 mpa. a heater in the wall of the tank

  Saturated liquid leaves the condenser at 006 bar the

superheated steam at 120 bar and 520c leaves the steam generator of a vapor power plant and enters a turbine with an

  A refrigeration cycle operates continuously and removes

a refrigeration cycle operates continuously and removes energy from the refrigerated space at a rate of 12000 btuh. the

  What is the nature of the process fluid

What is the nature of the process fluid and what are the objectives of the two sample points and in what way do the samples reaching the instruments differ?

  Steam flows steadily through an adiabatic turbine the inlet

steam flows steadily through an adiabatic turbine. the inlet conditions of the steam are 10 mpa 450 c and 80 ms and the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd