Tabulate the frequency-peak values and average powers

Assignment Help Electrical Engineering
Reference no: EM13250100

A full wave rectified current has a peak value of 20 A and a period of 2ms. Assume the current is flowing in a 50 ohm resistance. Tabulate frequency, peak values and average powers of the first four nonzero compoents in the spectrum.

Reference no: EM13250100

Questions Cloud

Create circuit that divide voltage and can handle the power : If you have a 30 VDC - 4A power supply and need to power two 24VDC - 0.8A MFC (mass flow controller), create a circuit that divide the voltage and can handle the power.
Define the molarity of the aqueous sodium hydroxide solution : In an acid-base titration 14.7 mL of .107M NaOH (aq) sodium hydroxide is needed to react to an end point with .1252 grams of H2C2O4 oxalic acid. Determine the molarity of the aqueous sodium hydroxide solution. 2NaOH + H2C2O4 ----> 2HOH + Na2C2O4
How does a transistor switch compare to a mechanical switch : How does a transistor switch compare to a mechanical switch. In other words, a mechanical switch when it is ON has zero impedance. What about the transistor switch.
Chemicals have the highest value for electrical conductivity : Which of the following chemicals have the highest value 1-10 for electrical conductivity when dissolved in water and why
Tabulate the frequency-peak values and average powers : A full wave rectified current has a peak value of 20 A and a period of 2ms. Assume the current is flowing in a 50 ohm resistance. Tabulate frequency, peak values and average powers of the first four nonzero compoents in the spectrum.
Building a payroll program for a large organization : Application Architecture. You have been tasked with building a payroll program for a large organization with offices spread across the United States.
Determine what is the population of interest : A consumer protection agency conducts opinion polls to determine the quality (excellent, good, fair, bad) of products imported. if the agency conducted a poll in wich 1000 randomly selected individuals were contacted..
Define what is the ph at the point in a titration : What is the pH at the point in a titration at which 20ml of 1.0M KOH has been added to 25ml of 1.0M HBr
Wil fence is a large timber and christmas tree : Wil Fence is a large timber and Christmas tree farmer who is attending a project management class in the fall, his off season. When the class topic came to earned value, he was perplexed. Isn’t he using EV?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the potential difference between the points

The electrostatic potential in space is given by the scalar field V(r)=V(x,y,z)=e^y + (3x)^2-4cos(z) Find the potential difference between the points P(1,1,1) and Q(0,0,0).

  Explain flet-compound generator has a shunt field

Each pole of a 100kW, 250v flet-compound generator has a shunt field of 2000 turns and a series field of 7 turns. If the total shunt field resistance is 100 ohms

  Where should substation be located to minimize the losses

Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..

  Calculate the voltage drop across the load

A simple power system consists of a dc generator connected to a load center via a transmission line. The load power is 100kW. The transmission line is 50km copper wire of 3 cm in diameter. If the voltage at the generator terminals is 400V

  Develop the pseudo-code

Develop the pseudo-code below for a program that will retrieve 2 bytes (NUM1 and NUM2) from memory, determine which is closest to the numeric value 50, and indicate the result by setting a variable named "CLOSEST" to 1 (if 1st byte is closest) or ..

  Does anyone has a homework related to calculate

Does anyone has a homework related to calculate: failure probability estimation of SRAM Bit-cell using matlab?

  Determine number of bit that must be specified for converter

A successive approximation A/D converter with range of 0 to 5 volts and a resolution of 0.05 volts is specified. It will be clocked at 500 KHz. a. Determine the number of bits that must be specified for this converter. b. Determine the t..

  Design a plc program and prepare a typical i/o connection

Each start/stop station contains one NO start pushbutton and one NC stop pushbutton.

  Which parameter has the largest impact on the output voltage

If these nominal non--ideal parameters are replaced, one at a time, by A = 50000, Ri = 1 M and R0 = 150 (each of which is twice as bad as the nominal values), which parameter has the largest impact on the output voltage

  Determine the rate of return for the project

A new project has the following predicted profits. The initial investment is $3,000,000. Yr Revenue 1 $200,000 2 $400,000 3 $600,000 4 $800,000 5 $1,200,000 6 $1,200,000 7 $1,400,000 8 $1,600,000

  What is maximum positive voltage and negative voltage

what is the open- circuit voltage. power supply has isolated +- 15V and +-6V outputs,what is the maximum positive voltage and maximum negative voltage that can be output from power supply.

  What is the power supplied by the current source

e) What is the value of C such that the energy stored in the capacitor equals the energy stored in the inductor f) How much energy is stored in the 3.9?F capacitor Use the formula for the energy. g) What is the power dissipated in the resistors

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd