Reference no: EM132993557

Question: Using Packet tracer implement the following tasks based on the network topology of a small business given below. Smart Univ Ltd has three branches: Albury, Bathurst and Wagga site. Each site has Admin Office to manage the local business. Wagga site has three buildings where has two major departments: Student group and Staff. Examine the network requirements and complete the following questions to make the company network service running.

You must submit your answer file in word or pdf and TWO packet tracer files to EASTS by the due date.

Please use your last 4 digits of your student ID as the first two octets of your network address. Keep other bits same as what are shown in the addressing table and the figure below. For example, if your student ID is 11567890, using the last 4 digits (7890), your main network address will be 78.90.0.0.

Consider the following Topology in the figure below:

Addressing Table

You need to use Packet Tracer to implement the given topology and to complete the following tasks:

Part A: Switching, VLANs and Inter-VLAN Routing
1. It is quite important to lock down access and install strong security features on PCs and servers. It is important that your network infrastructure devices, such as switches and routers, are also configured with security features. What is the best practice to prevent mac address flooding attacks?
2. Port security allows you to restrict a port's ingress traffic by limiting the MAC addresses that are allowed to send traffic into the port. Please advise your solution to improve the switch1 port security.
3. PAgP and LACP are negotiation protocols that dynamically configure an Etherchannel. What's the difference between them?
4. Configure three VLANs as required on the switch and enable Trunking on the switch.
5. Configure inter-VLAN routing on Router wagga based on the Addressing Table.
6. Configure RIP/static routing on each router to build up full connectivity between each site to ISP and the Internet server.
7. Verify connectivity by making sure all the PCs can ping the Internet server and ISP
8. When a packet arrives on a router interface, the router examines the IPv4 header, identifies the destination IPv4 address, and proceeds through the router lookup process. Please analyse the routing process of routers in the case of ping from Student group 1 to the Internet server.
Please save your configured packet tracer file with the name of "PT_your studentID_partA"

Part B Router hop redundancy

9. A first hop redundancy protocol (FHRP) is a computer networking protocol which is designed to protect the default gateway used on a subnetwork by allowing two or more routers to provide backup for that address; in the event of failure of an active router, the backup router will take over the address. Please configure FHRP on Router Wagga and Router Albury, use the virtual router IP of xx.xx.xx.254.

Attachment:- Packet tracer.rar