Stress equals youngs modulus times strain

Assignment Help Mechanical Engineering

Reference no: EM13718454

Hookes Law (Stress equals Young’s Modulus times Strain; or s=Ee) is valid for both linear tensile behaviour and torsion (or shear) as well (e.g. t=Gg). Imagine a shear test of annealed, mild steel (e.g. AISI 1020). It is sheared until it just starts to yield (normal yield is about 36 ksi). How many degrees of shear will have been applied? Note that the angle of shear approximates the value of shear for small, elastic deformations. Recall, G is the torsion (or shear) modulus (about 10 msi for 1020 steel). Also, yield in shear is about half that in tension.

Reference no: EM13718454

Questions Cloud

An air-standard otto cycle has a compression ratio : An air-standard Otto cycle has a compression ratio of 6. At the beginning of compression, the pressure is 100 kPa and the temperature is 300 K. During the heating process, the temperature is raised to 2500 K. Assume that the cold air-standard assumpt..

Determine the flow rate of oil through the pipe : Oil at 80°F, density r = 56.8 lbm/ft3 and viscosity m = 0.0278lbm/ft.s is flowing steadily in a 0.5in diameter 120ft long pipe. The pressure at the pipe inlet is 120 psi and at the outlet is 14 psi. Determine the flow rate of oil through the pipe ass..

Global climate change scientist predict earths atmospheric : Due to global climate change scientist predict the earth’s atmospheric temperature will increase as much as 8°F in the next 100 years. Estimate the overall energy increase [kJ] in the atmosphere this temperature rise will cause. Consider the thicknes..

Specific heat at saturation of a liquid phase of mass : Show that the specific heat at saturation of a liquid phase of mass m (defined by Cf= (deltaQ/m)dt is generally not the same as the specific heat at constant pressure of the saturated liquid.

Stress equals youngs modulus times strain : Hookes Law (Stress equals Young’s Modulus times Strain; or s=Ee) is valid for both linear tensile behaviour and torsion (or shear) as well (e.g. t=Gg). Imagine a shear test of annealed, mild steel (e.g. AISI 1020). It is sheared until it just starts ..

What is the calculated modulus in msi : Consider a one-foot long 1/16" diameter steel wire pulled to a load of 350 pounds, while stretching only 0.045" . What is the calculated modulus in msi (use three significant digits)?

Three-point bending test was performed on a glass specimen : A three-point bending test was performed on a glass specimen having a square cross-section of 15 mm length on each edge. The specimen fractured at a load of 4770 N when the distance between the support points was 41 mm.

Reduce crack length and increase tip radius : The fracture strength of glass may be increased by etching away a thin surface layer. It is believed that the etching may alter the surface crack geometry (i.e. reduce crack length and increase tip radius). Calculate the ratio of the etched and origi..

Determine temperature in celsius of equilibrium ice water : Estimate the slope dp/dt of the ice +water line using the triple point information. Specific entropy of ice at the triple point is -1221J/kgK , specific entropy of liquid water at triple point is 0.0 J/kgK. Determine therefore the temperature in Cels..

User Account

All Pages