Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A unidirectional E-Glass fiber-epoxy composite material contains 61% by volume E-Glass fibers stressed under isostrain conditions. The E-Glass fibers have a tensile modulus of 10x106 psi, and a tensile strength of 0.35x106 psi. The epoxy matrix has a tensile modulus of 0.45x106 psi, and a tensile strength of 9.0x103 psi. What is the strength of the composite material and what fraction of the load is carried by the E-Glass fibers?
A simple plate capacitor can store 6.5x10-5 C at a potential of 10,000 V. What dielectric constant must the material between the plates have if their area is 6.0x10-5 m2 and they are 0.16 mm apart?
It is desired to produce 5 cubic yards of concrete with a ratio of 1:1.8:3.5 (by weight) of cement, sand, and gravel. What are the required amounts of the components if 5.5 gallons of water per sack of cement is to be used? Assume the free moisture contents of the sand and gravel are 3% and 0.75% respectively. The specific gravities of the cement, sand, and gravel are 3.15, 2.65, and 2.65 respectively. (1 sack of cement weighs 94lb, and 1ft3 of water=7.48 gallons). Give the answere for cement in sacks, the sand and gravel in pounds, and the water in gallons.
Describe how I/O ports are accessed in system that uses Memory-Mapped I/O and how they are accessed in a system that uses Direct I/O. List the advantages and disadvantages of each type of port addressing.
1.xyz corporation is a manufacturer of widgets. over the past several months it has been selling its widgets for 100
Interface TTL logic to 120 VAC lamp. In this part of the lab, you will interface lowpower solid state electronics to the "outside world" by switching the 120 VAC lamp on and off using the AND gate from the previous experiment.
Find the Thevenin's Equivalent Circuit between terminals a and b in the circuit
A 50 hp, 460 V, three phase induction motor draws 61 amps when operating at rated voltage and at a power factor of 0.85 lagging when supplying a rated load. knowns: 1hp=746watts effeciency (n) = Pout/Pin = Pout/(Pout+losses)
A system is described by the differential equation ty'(t)-8y(t)=x(t). Classify the system as to linearity, time-invariance and stability. A system is described by the equation y(t)= \(\int_{t/3}^{-\infty}\)x( \(\lambda\)) d.
a)Design the corresponding scrambler. b)Design the corresponding descrambler. c)Determine the output sequence T. d)Verify that if this T is applied to the input of the descrambler, the output is the sequence S.
What is the maximum data rate possible for a standard telephone circuit with an SNR of 1023 and BW of 3 KHz using 8 bits per symbol
The dielectric constant of LiF is 9.27 at low frequencies and approaches 1.9 at high frequencies. What are the percentage contributions of electronic and ionic polarization to the low-frequency polarization
Design a State Sequencer using T Flip-Flops and NAND Gates that Cycles through the Prime Numbers (1, 2, 3, 5, 7) in ascending order if the select input "S" is set; Otherwise (if "S" is 0) it cycles through 0, 4, and 6.
can you solve the attached file its only one question ltbrgt ltbrgtam expecting good price on it... ltbrgt ltbrgt
At what temperature are the two carrier densities equal?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd