Steam flows steadily through an adiabatic turbine

Assignment Help Mechanical Engineering

Reference no: EM13709598

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10MPa, 450C and 83 m/s, and the exit conditions are 10kPa, 92 percent and 42 m/s. The mass flow rate of the steam is 12 kg/s.

Determine

a) the change in kinetic energy (kJ/kg)

b) the power output (MW)

c) the turbine inlet area (cm2)

Reference no: EM13709598

Questions Cloud

Typical towns in states with big plains like texas : Typical towns in states with big plains like Texas need an elevated tank to supply tap water. Below there is a picture of a typical elevated tank. If we approximate the tank as a cylinder with a diameter of 50 ft and a height of 25 ft, answer the fol..

Calculate the heat transfer per unit mass of water : Water enters a boiler at 160 psia as a saturated liquid and leaves at 600 degree F at the same pressure. Calculate the heat transfer per unit mass of water.

What is the composition of the alpha phase : A hypothetical A-B alloy of composition 56 wt% B-44 wt% A at some temperature is found to consist of mass fractions of 0.5 for both alpha and beta phases. If the composition of the beta phase is 88 wt% B-12 wt% A, what is the composition of the alpha..

Find the initial pressure and mass of the system : Water in the pictured piston cylinder assembly has an initial quality of 10%. The piston cylinder is 20 cm in width and the piston is initially 40 cm high. Heat is added until the temperature of the steam reaches 500°C. While heat is being added the ..

Steam flows steadily through an adiabatic turbine : Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10MPa, 450C and 83 m/s, and the exit conditions are 10kPa, 92 percent and 42 m/s. The mass flow rate of the steam is 12 kg/s.

The initial and final phase descriptions of the water : One-half kilogram of pure water is heated in a frictionless piston-cylinder device, at a constant pressure of 200 kPa, from an initial temperature of 20oC to a final temperature of 400oC.

Kinetic energy of the air within the chamber is negligible : An air cushion vehicle is supported by forcing air into the chamber created by a skirt around the periphery of the vehicle as shown in Fig. P3.106. The air escapes through the 1.7-in. clearance between the lower end of the skirt and the ground (or wa..

Determine the size of the contact patch and contact stresses : Determine the size of the contact patch, the contact stresses, and the maximum shear stress for a 40 mm diameter steel cylinder, 25 cm long, rolled against a flat plate with a 4 kN force pressing the cylinder onto the flat plate.

Masses connected together with a mass less rigid-link : Given three masses connected together with a mass less rigid-link, where should you place the single mass if you want to replace these masses with it?

User Account

All Pages