Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Static and Dynamic Routing
1. A network engineer is troubleshooting a small LAN network with one border router, GW01 that connects to the Internet Service Provider's (ISP) network. GW01 uses its Serial 0/2/1 interface to connect to the ISP's router. Everyone on the LAN network lost connectivity to the Internet. Upon troubleshooting the issue, the network engineer notices the following message after typing show ip route.
Gateway of last resort required but not set.
What do you suggest the network engineer do to rectify this issue? Assume the problem is only on the organization's LAN side of the network. Provide as much information as possible including specific commands and all required parameters.
2. A Cisco router has learned the following destination prefix 209.175.28.0 /24 from its directly connected network, static routing, and via dynamic routing. List in order of importance the way the router will go about inserting the route in its final routing table assuming everything is now working. What is the Cisco router using to make that decision? Explain when the dynamic routing protocol information will be utilized in the routing table.
3. The show ip interface brief command executed on router1 R1 and R2 generated the following output. What would be the static route commands that you would type on R2 in order to reach R1's subnets. Provide complete configuration command with destination prefixes and next-hop information or exit interface. Assume R1 is already configured.
calculate the resistance of a platinum wire that is 2 m in lenth and has a diameter of 0.1cm. the resistivity of
magneto is seeking to produce a new helmet using a deep drawing process in which a sheet of 3103 aluminum will be
A power plant with one closed FWH has a con- denser temperature of 450C, a maximum pressure of 5 MPa, and a boiler exit temperature of 900C. Extraction steam at 1 MPa to the FWH condenses and is pumped up to the 5-MPa feed water line, where all the w..
saturated ammonia vapor at 30 degree in celcius is passed over 30 vertical flat plates each of which is 10 cm high and
a pressure transducer exhibits a temperature sensitivity of 0.05 units per degree celsius and a pressure sensitivity of
a cylinder subjected to internal pressure pi only is made of cast iron having ultimate tensile strengths in tension and
The question related to Mechanical Engineering and the question is about drawing outlet and inlet valves for a compressor for controlling compressor. The symbols have been drawn with standard ISA symbols
Air with a mass flow rate of 1.5 kg/sec and temperature of 400 K flows through a horizontal duct of an air heater. If 36 kJ/sec of heat is added to the flow, determine the air exit temperature. Assume ideal gas and neglect any change in pressure and ..
a piston cylinder arrangement originally contains 0.1 kg of saturated water vapor at 10 bars. a line with steam flowing
a piston-cylinder device contains 0.398 kg of refrigerant-134a at -10 degrees celsius. the piston that is free to move
a circular sheet metal duct carries refrigerated air to a cold storage room for apples. the duct itself is 200 mm in
the city of mcallen has a water filtration system that consists of a large rigid tank with a single 0.32 m diameter
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd