Statement is correct as regard to up milling

Assignment Help Other Subject

Reference no: EM13281528

Which of the following statement is correct as regard to up milling?

A. It can not be used on old machines due to backlash between the feed screw of the table and the nut.

B. The chips are disposed off easily and do not interfere with the cutting.

C. The surface milled appears to be slightly wavy.

D. The coolant can be poured directly at the cutting zone where the cutting force is maximum.

Reference no: EM13281528

Questions Cloud

Difference between epoxy grout-cement grout : What is the difference between epoxy grout, cement grout and cement mortar?

Calculate the resistivity at room temperature : an N-type silicon substrate with doping density of 1015 cm-3 Arsenic is to be converted in tp p-type by Boron diffusion so the resistivity at T=75C is 5Ω-cm all atoms are fully ionized

The fourth period the asset disappears : In the fourth period, if the asset survives, you will be 10. the fourth period the asset disappears. The interest rate between periods is 0 percent. How much is your asset worth today ?

What is the terminal speed of the marble : A boy on board a cruise ship drops a 30.0 g marble into the ocean. what is the terminal speed of the marble

Statement is correct as regard to up milling : Which of the following statement is correct as regard to up milling?

State and explain the net ionic equation : write the net ionic equation, excess concentrated sulfuric acid is added to solid calcium phosphate

Find what is the resistnace between the two faces : A large brass washer has a 2 cm inside diameter, a 5 cm outside diameter, and is 0.5 cm thick. Its conductivity is s=1.5 X 107 S/m. The washer is cut in half along a diameter, and a voltage is applied between the two rectangular faces of one part.

Calculate the torque on the center of mass of the rod : A uniform rod of length 0.940 m and mass 11.0 kg is balanced on a sharp edge at 0.670 m from the left end. Calculate the torque on the center of mass of the rod alone with respect to the pivot point

Side rake angle of a single point cutting tool is the angle : Side rake angle of a single point cutting tool is the angle

User Account

All Pages