State what is the identity of the metal

Assignment Help Chemistry
Reference no: EM13280513

An unidentified metal crystallizes in a body-centred cubic lattice with an edge length of 429 pm. The density of the metal is found to be 0.967 g/cm 3 . What is the identity of the metal

Reference no: EM13280513

Questions Cloud

What is the effective cost of borrowing in this case : Your firm has an average collection period of 25 days. Curret Practice is to factor all receivables immediately at a 1.5 percent discount. What is the effective cost of borrowing in this case?
Which factors influence a person capacity for social mobile : Which factors influence a person’s capacity for social mobility? 850 word each...both question need 5 reference+ the subject text is "Stratification: social division and inequality"
Determine how much current must a logic output source : How much current must a logic output source, in order to maintain an output voltage of 2.5V when driving a 5K resistor connected to ground.
What is the degree of operating leverage at the financial : What is the degree of operating leverage at the financial break-even level of output?
State what is the identity of the metal : An unidentified metal crystallizes in a body-centred cubic lattice with an edge length of 429 pm. The density of the metal is found to be 0.967 g/cm 3 . What is the identity of the metal
What would be the maximum length if choosed a wavelength : Build a 1Gbps link as long as possible without regeneration. Assume a transmitter power of 1mW and a receiver sensitivity of -30dBm for a BER of 10^(-9). The dispersion at 1.5 micron is 20 ps/km.nm, and the attenuation is 0.25 dB/km.
What is the estimated ocf for this project : The engineering department estimates you will need an initial net working capital investment of $580,000. You require a 18 percent return and face a marginal tax rate of 30 percent on this project.
How far does the ball go before your dog catches it : You roll a ball along the floor for your dog to chase after and catch it. You roll the ball with an initial speed of 15 m/s, how far does the ball go before your dog catches it
Calculate de and determine the process is endothermic : Calculate DE, and determine whether the process is endothermic or exothermic for the following cases: q = -142 kJ and w = -530 kJ.

Reviews

Write a Review

Chemistry Questions & Answers

  Compute the henry''s law constant of o2

The solubility of O2 in water is 6.5 mg/L at an atmospheric pressure of 1.0 atm and temperature of 40 degrees C. Calculate the Henry's Law constant of O2 at 40 degree C. The mole fraction of O2 in air is .209

  Explain what dose in rads will the brick absorb

The alpha particles emitted by radon-222 have an energy of 8.8 x 10^-13 J. If a 200. g Pb brick absorbs 1.0 x 10^10 alpha particles from radon decay, what dose in rads will the brick absorb

  What volume of naoh is needed to reach the end point

flask contains 10.0 mL of HCl and a few drops of phenolphthalein indicator. The buret contains 10.0 mL of 0.220 M NaOH. 1. what volume of NaOH is needed to reach the end point of the titration?

  Calculate the ph of the solution

A 50.00-mL sample of 0.100 M KOH is titrated with 0.152 M HNO3. Calculate the pH of the solution after 52.00 mL of HNO3 is added.

  Compute the partial pressure of oxygen produced

Calculate the partial pressure of oxygen produced from 1.00L of 0.600M dinitrogen pentoxide solution at 45 degrees celsius over a period of 20.0hours if the gas is collected in 10.0L container. (Assume that the products do not dissolve in chlorofo..

  Compute the ph of the buffer ka

Calculate the pH of this buffer if it is .10 M HC2H3O2 and .10 M C2H3O2-. The Ka for CH3COOH is 1.8x10^-5.

  What is the entropy of a mixture made

what is the entropy of a mixture made of 2.4 moles of O2 and 9.2 moles of N2 at the same temperature and pressure?

  Explain payload if helium were used instead of hydrogen

what would be the payload if helium were used instead of hydrogen?, d.) would you and a companion on board, the balloon ascends to 30,000 feet where pressure is 0.28 atm. Assume no volume change, what is the temp (in celsius) at 30,000 feet?

  Calculating the amount of sugar

A large pond is 300m by 95m with an average depth of 2.5m. Assuming that the pond is saturated with oxygen, calculate the amount of sugar (C12H22O11) in kg that would be sufficient to completely consume the dissolved oxygen.

  State electrical power plants fueled by coal

carbon dioxide which is recognized as the major contributor to global warming as a greenhouse gas is formed when fossil fueels are combusted, as in electrical power plants fueled by coal, oil, or natural has.

  Explain what was the percentage by mass of mg(oh)2

What was the percentage by mass of Mg(OH)2 in the original sample? [Hint: When Mg(OH)2 or Al(OH)3 reacts with HCl(aq), the products are a chloride salt, water and CO2(g). Assume that all of the CO2(g) leaves the solution without reacting.]

  Compute the molarity of a solution made by dissolving

calculate the molarity of a solution made by dissolving 12.5 grams of Na2CrO4 in enough water to form exactly 550mL of solution

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd