State what is the change in the measurement of the potential

Reference no: EM13226682

I did an experiment in the lab called Potentiometric Determination of Fluoride. There is a series of questions that i need help to answer:

1) Explain the effect it would have if no constant ionic strength is maintained when performing potentiometric measurements.

2) A standard solution of NaF 1.00x10-3 M read -0.230V. The solution of an unknown read -0.300V. What is the [F-] in the unknown solution?

3) What is the change in the measurement of the potential if a solution of 1.00x10-3 M NaF is exchanged for another solution of 1.00x10-4 M NaF?

Reference no: EM13226682

Questions Cloud

Explain what is the maximum ratio compatible with atp : what is the maximum [ATP]/[ADP][Pi] ratio compatible with ATP synthesis assuming that the number of protons trans-located per ATP formed is 2, the temperature is 25C and the change of pH is 0.75?

Design circuit using only two-three and four-input nand gate : Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.

Find out the number of mols of hydrogen in the compound : the reaction produces 0.90 mol of CO2 and 0.45 mol of H2O. Determine the number of mols of carbon in the compound. Determine the number of mols of hydrogen in the compound.

Describe briefly the nature of the organization : Describe briefly the nature of the organization itself, its Operations and Quality Management systems and how these systems improved and contributed to the organization's current success.

State what is the change in the measurement of the potential : What is the change in the measurement of the potential if a solution of 1.00x10-3 M NaF is exchanged for another solution of 1.00x10-4 M NaF?

Find out the value of the overall reaction : Determine the value of the overall reaction order in the rate law expression. Rate=k[A]^n [B]^m, from the following data.

What is initial value if the overhead values were considered : write an 8051 program that would generate a 200khz, 50% duty cycle, square wave at P1.0.Use Timer 0 for the delay. Ignore the overheads cycles due to the instructions in the loop. Assume 12 MHz clock. All data must be hex.

Determine the optimal production schedule for month : Set up the Transportation Table, model for this problem, use NW corner, Least cost, and Vogel methods to find the initial feasible solutions and what is the optimum solution

Explain what is no3- in the final aqueous solution : The next items refer to the result of mixing 400. ml of 0.10 M NaOH and 100.0 mL of 0.10 M Mg(NO3)2. Reaction as shown goes essentially to completion.

User Account

All Pages