State solute concentration on the feed side of the membrane

Assignment Help Chemistry
Reference no: EM13284244

You are concentrating a solution containing a polypeptide of modest molecular weight by pressure filtration through a membrane. The solute concentration on the feed side of the membrane is 0.10 M and the temperature is 25°C. The applied pressure on the solute side of the membrane is 6 atm (absolute) and the pressure on the opposite (solvent) side of the membrane is atmospheric. If the polypeptide solute is completely rejected by the membrane (i.e., it does not cross the membrane) and the solution is ideal, what is the "effective" pressure difference across the membrane? If the hydraulic conductance of the membrane is 3 ml/hr/m2/mm Hg, what is the filtration rate of the solvent? Assume the membrane has a total surface area of 1 m2.

Reference no: EM13284244

Questions Cloud

Calculate the total market value : In addition, the company has a second debt issue on the market, a zero coupon bond with three years left to maturity; the book value of this issue is $76 million and the bonds sell for 78 percent of par.
Explain how many potassium ions must a cell lose : How many potassium ions must a cell lose in order to produce a membrane potential of - 95 mV for potassium? How does this compare to the number of potassium ions within the cell
What is the magnitude of the attractive force : Three equal positive point charges of magnitude Q = 3.00? C are located at three corners of a square of edge length d = 8.9 cm. What is the magnitude of the attractive force on the negative charge
What do you consider your most significant learnings from it : Hinduism (Gandhi and his Satyagraha Movement). What do you consider your most significant learnings from it?
State solute concentration on the feed side of the membrane : You are concentrating a solution containing a polypeptide of modest molecular weight by pressure filtration through a membrane. The solute concentration on the feed side of the membrane is 0.10 M and the temperature is 25°C.
What is the field just outside the shell : A point charge Q = 8.50×10-6 C is at the center of a conducting spherical shell of radius R = 17.90 cm. What is the field just outside the shell
Show how to implement this generator using sequential logic : You are to design a Gray code sequence generator.The 4-bit Gray-code sequence is defined as follows: 0000, 0001,0011, 0010, 0110, 0111, 0101, 0100, 1100, 1101, 1111, 1110, 1010,1011, 1001, 1000.
Explain cycloalkane ten carbon atoms : Draw the structure of an alkane or cycloalkane that has more than three but fewer than ten carbon atoms, and only primary hydrogens.
Explain cycloalkane ten carbon atoms : Draw the structure of an alkane or cycloalkane that has more than three but fewer than ten carbon atoms, and only primary hydrogens.

Reviews

Write a Review

Chemistry Questions & Answers

  State the mercury level in an open-end manometer connected

If the barometeric pressure was 0.98 atm when the mercury level in an open-end manometer connected to a flask of gas was 177 mmHg higher on the side open to the atmosphere than on the flask side

  How much heat is absorbed

How much heat is absorbed when 45.00 g of C(s) reacts in the pressence of excess SO2(g) to produce CS2(l) and CO(g) according to the following chemical equation?

  What is the final volume of the balloon

A balloon is filled to a volume of 7.00 x 102 mL at a temperature of 20.0 oC. The balloon is then cooled at constant pressure to a temperature of 1.00 x 102 K.

  State what is the mole fraction of magnesium chloride

what is the mole fraction of magnesium chloride in a solution prepared by adding 15 grams of magnesium chloride

  Use the half reaction method for equation in acidic solution

Use the half reaction method to balance the following equation in acidic solution. It is not necessary to include any phases of matter for any species. It is not necessary to include any phases of matter for any species.

  Compute an approximate atomic radius for copper

Use the density of copper (8.95 g/cm3) and its molar mass (63.55 g/mol) to calculate an approximate atomic radius for copper.

  Sodium fluoride should be added to prepare buffer solution

How many grams of sodium fluoride should be added to prepare the buffer solution? Neglect the small volume chane that occurs when the sodium fluoride is added.

  Explain how many moles of methanol are present

How many moles of methanol are present in a 150.0 gram sample of methanol,CH3OH

  Compute the oxygen content of the plasma in mm

How many ml of oxygen is dissolved in 50 ml blood plasma at 38 degrees C, if the partial pressure of oxygen in the plasma is 13.3 kPa?

  Use charles law to calculate the volume the gas

Use Charles's law to calculate the volume the gas will occupy if the temperature is increased to 170.5^circ C while the pressure is held constant.

  Determine the keq for the reaction of benzoic acid

The pKa's of benzoic acid and 4-nitroanilinium hydrochloride are 4.2 and 1.0, respectively.

  Define solution of aqueous ammonia

Consider a titration of 24.2 mL of 0.0878M solution of aqueous ammonia [Kb(NH3) = 1.8e-5] with a 0.115M of hydrochloric acid.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd