State cuvette placement to avoid pre-and post-filter effects

Assignment Help Chemistry

Reference no: EM13168696

1. Why are electrothermal atomizers generally "better" for atomic absorption?

2. Why are fluorescence measurements made at 90 degrees from the incident beam in most cases?

3. What is the ideal cuvette placement to avoid pre- and post-filter effects?

4. What can you do if your intended analyte does not fluoresce (give two options)?

5. Consider the symmetric stretching of carbon tetrachloride (CCl4). Explain why this stretch is not IR active, but is Raman active.

6. Why is it generally better to measure Raman scattering at longer wavelengths, even though Raman signal drops as wavelength increases (1/?4 dependence)?

7. Why are notch filters used in Raman spectroscopy?

8. Consider a Raman band with a Raman shift of 460 cm-1. If the laser is switched from afrequency-doubled Nd:YAG (532 nm) to

a HeNe laser (633 nm), What will the Raman shift (cm-1) of the same Raman band be?

9. What is the main drawback of Surface-enhanced Raman scattering (SERS)?

10. What causes poor signal-to-noise at low absorbance? At high absorbance?

Reference no: EM13168696

Questions Cloud

Explain what is a zymogen : What is a zymogen? Is it used over and over like other enzymes? And what is the physiological advantage

What is the amount dubois will receive on the sale : What is the interest rate, to the nearest percent, used in discounting this purchase transaction and what is the amount Dubois will receive on the sale of the note?

Actual cost method : Compute Amelie's deduction before the 2% of AGI floor if she uses the actual cost method and compute Amelie's deduction before the 2% of AGI floor if she uses the standard mileage method.

Explain whats the concentration of the ammonia solution : ammonia solution required 10.83 mL of 0.9760 M HCl to reach endpoint, whats the concentration of the ammonia solution?

State cuvette placement to avoid pre-and post-filter effects : Why are fluorescence measurements made at 90 degrees from the incident beam in most cases? 3. What is the ideal cuvette placement to avoid pre- and post-filter effects?

Explain whats the concentration of the acetic acid solution : whats the concentration of the acetic acid solution? If 10.91 mL of an acetic acid solution required 9.78 mL of 1.0439 M NaOH

Journalize and post the adjusting entries : Prepare a trial balance, and enter it on a 10-column worksheet with columns for a trial balance, adjustments, and adjusted trial balance, an income statement, and a balance sheet.

State alcohol dehydrogenase requires nicotinamide adenine : DNA polymerase (DNA pol) requires divalent magnesium for activity. Alcohol dehydrogenase (ADH) requires nicotinamide adenine dinucleotide

State correct balanced equations for reaction : A saturated solution of an unknown solid reacted with AgNO3 to give a pale yellow precipitate and also reacted with Pb(NO3)2 to give a white precipitate.

User Account

All Pages