Stainless steel rod with circular cross section has length

Assignment Help Mechanical Engineering

Reference no: EM13708077

A stainless steel rod with a circular cross section has a length of 100 mm and a diameter of 2.0 mm. It is deformed elastically in compression by a force of 500 N applied parallel to its length. The material has a Young’s modulus of 200 GPa, and a shear modulus of 77 GPa. Calculate (i) the amount by which the rod will decrease in length, and (ii) the amount by which the rod will increase in diameter.

Reference no: EM13708077

Questions Cloud

The double-acting piston cylinder-frictionless piston : The double-acting piston cylinder shown below consists of two chambers separated by a frictionless piston. The piston is initially locked in place, dividing the device into two equal 1 m3 sub-chambers. Side A contains water at 90°C and a quality of x..

Include metallization pads in your mask design : Design a mask set and process flow that would produce a 50000 Ohm resistor patterned onto the surface of an initially n type silicon wafer (0.18 ohm-cm, Phosphorous doped). Include metallization pads in your mask design. Use a two step predisposition..

What is heat transfer rate from air into the cooling coil : An air conditioning unit has two inlet air streams: a stream of return air from the building (2.25 kgs at 25C) and a steam of outside air (0.75 kg/s at 30 C). These streams are blended and then colled by a cooling coil to 20 C.

Determine the surface temperature in degree rankine : A radiator surface on a spacecraft is sized to deliver 1000 W heat load to deep space where the sink temperature is assumed to be 10 K. the radiator surface is 10 m x 1 m and has a solar abosrptance of 0.2 and an emissivity of 0.8. Determine the surf..

Stainless steel rod with circular cross section has length : A stainless steel rod with a circular cross section has a length of 100 mm and a diameter of 2.0 mm. It is deformed elastically in compression by a force of 500 N applied parallel to its length. The material has a Young’s modulus of 200 GPa, and a sh..

Self-interstitials do not form in pure metals : Given values of the diffusion coefficient for carbon in iron at 850°C and 950°C, we can calculate the activation energy for the diffusion of carbon in iron. the activation energy for vacancy migration in copper, we can calculate the activation energy..

Oxygen-rich and virtually carbon-free environment : An iron-carbon alloy initially containing 0.55 wt% C is exposed to an oxygen-rich and virtually carbon-free environment at 1325 K. Under these conditions, the carbon diffuses from the alloy and reacts with oxygen at the surface.

Determine the amount if change in internal energy : A system experiences a heat transfer into the system of 50 Btu and does work against the surroundings of 2100 ft-lbf reducing its horizontal velocity from 2 fps to 1.5 fps. The mass of the system is 3 lbm. Determine the amount if change in internal e..

Weight and the air pressure outside the roof hold it down : Movement of stagnant air over a surface typically decreases the pressure that air exerts on the surface it was in contact with, and higher air velocities usually result in more significant pressure drops. This pressure drop from rapidly moving air ac..

User Account

All Pages