Spinal fluid pressure can be measured using a spinal tap

Reference no: EM13549607

Spinal fluid pressure can be measured using a spinal tap in which a needle is inserted in the patient's lower back with the patient sitting upright on an examination table. The pressure due to the weight of the spinal fluid (given that its density is 1050 kg/m^3) in the spinal column increases the pressure. (a) What is the pressure measured if the pressure around the brain is 10 mm Hg and the tap is at a point 75 cm lower than the brain? (b) What is the pressure measured if the person is lying down?

Reference no: EM13549607

Questions Cloud

Develop a decision support model using visual dss : Develop a decision support model using Visual DSS using the variables described above. Include comments within your Visual DSS model to explain the variables and your calculations.

Evaluate what is the current in the wire : 0.800-v potential difference is maintained across a 1.60-m lenght of tungsten wire (the resistivity of tungsten is 1x10-5 resistance cm) that has a corss-sectional area of 0.800mm2 what is the current in the wire

Estimate the total energy in the circuit : An oscillating LC circuit consists of a 73.7 mH inductor and a 5.39 ?F capacitor. If the maximum charge on the capacitor is 3.74 ?C, what are the total energy in the circuit

What is the specific heat of the unknown material : A 50-g block of an unknown material is at 530°C. It is dropped into a thermally insulated cup containing 0.07L of water at 20°C. If the temperature of the compound rises to 50°C, what is the specific heat of the unknown material?

Spinal fluid pressure can be measured using a spinal tap : Spinal fluid pressure can be measured using a spinal tap in which a needle is inserted in the patient's lower back with the patient sitting upright on an examination table. The pressure due to the weight of the spinal fluid (given that its density..

What is the gauge pressure at the bottom of the tube : A bottle of saline solution (with a specific gravity of 1.02) is attached to a 1.2 m long piece of tubing with a 1.0 cm inner diameter. If the tubing is held vertically, filled with saline, and clamped at the bottom, (

Determine the mass flow rate and exit velocity of the steam : Steam enters at 4 MPa and 400 degrees C enters a nozzle steadily with a velocity of 60 m/s, and it leaves at 2 MPa and 300 degrees C. The inlet area of the nozzle is 50 cm^2, and the heat is being lost at a rate of 75 kJ/s. Determine the mass flow ra..

Calculate and label the force due to gravity : Right as the cup begins to slide the applied force is equal to the force of friction-draw a free body diagram for each type of cup, Calculate and label the force due to gravity mg

Determine rate at which heat is lost through casing turbine : A steam turbine operates with 1.6 MPa and 350 degrees C steam at its inlet and saturated vapor at 30 degrees C at its exit. The mass flow rate of the steam is 16 kg/s, and the turbine produces 9000 kW of power. Determine the rate at which heat is los..

User Account

All Pages