Solar water heater operating at steady state heats water

Assignment Help Mechanical Engineering
Reference no: EM13711895

A solar water heater operating at steady state heats water from 90F to 120F. The panel is 3600 Btu/hr. Determine 1) the mass flow rate of the water in lb/min and 2) the volume of 120F water after 1 hour in gallons.

Reference no: EM13711895

Questions Cloud

Compute what was its initial velocity : If a net acceleration of magnitude 5.00m/s2 is applied to a cart such that after 25 seconds it has a displacement of 75m, What was its initial velocity
What average force acted on the ball during this time : A 0.56kg billiard ball initially at rest is given a speed of 14m/s during a time interval of 5.0ms. What average force acted on the ball during this time
Analyse the characteristics and processes of effective teams : Analyse the characteristics and processes of effective teams, as well as the issues related to team development and management.
Find the magnitude of the angular acceleration : A stick is resting on a concrete step with 1/7 of its length hanging over the edge. What is the magnitude of the angular acceleration of the stick at the instant shown
Solar water heater operating at steady state heats water : A solar water heater operating at steady state heats water from 90F to 120F. The panel is 3600 Btu/hr. Determine 1) the mass flow rate of the water in lb/min and 2) the volume of 120F water after 1 hour in gallons.
The stagnation temperature and stagnation pressure : Air flows at the rate of 1kg/s through a convergent-divergent nozzle. The entrance area is 2x10^-3 m^2 and the inlet temperature and pressure are 438 K and 580 kPa. If the exit pressure is 140 kPa and the expansion is isentropic, find;
Find the overall angular magnification of the microscope : The focal length of the eyepiece of a certain microscope is 18.0mm. The focal length of the objective is 8.00mm. find the overall angular magnification of the microscope
Estimate at what angle should the cannon be fired : A cannon with a muzzle speed of 992 m/s is used to start an avalanche on a mountain slope. At what angle, above the horizontal, should the cannon be fired
What are the mole fractions of the liquid phase : A vapor composed of 0.90 mole fraction ethanol and 0.10 mole fraction acetic acid at 120.0 mmHg (absolute), is in equilibrium with a liquid phase also composed of ethanol and acetic acid.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the electric power input to the oven per unit

The electric reheating oven shown in the figure is used to heat a continuous sheet of metal from 25-1000C The metal speed is such that the strip of metal spends 2 hours inside this oven, The sheet thickness is 1cm and the ambient temperature is 25C w..

  A simple ideal brayton cycle with air as the working fluid

a simple ideal brayton cycle with air as the working fluid has a pressure ratio of 11. the air enters the compressor at

  A given liquid has a temperature 178 celcius at a pressure

a given liquid has a temperature 178 celcius at a pressure of 47 mpa. if the enthalpy of the saturated liquid at the

  Find number of independent dimensionless parameters

Pressurised tank drained through a smooth nozzle, area A m(dot) = m(dot)(del p ,h, row, A, g) Find: number of independent dimensionless parameters. obtain the parameters

  Compare to the actual performance

Get information about a car engine .drive the ideal performance using the appropriate cycle and compare to the actual performance.

  What is the change of energy stored in the battery

A 12 Volt battery is charged by supplying 3 Amps over a period of 6 hours. What is the change of energy stored in the battery if the battery loses 400kJ of heat during charging.

  Determine the reduction in heat loss per unit length after

to reduce heat losses from a horizontal isothermal cylinder of radius ri 20 mm which is located in a large room in

  What is the initial volumetric flow rate of water out of

a garden hose is open at one end and capped closed at the other. a swimmer in an above-ground pool fills the hose with

  Find the final pressure

Steam at 300°C and 200 kPa is contained in a rigid tank of volume 0.36 m3. The tank is cooled while 350 kJ of heat are removed. Find the final pressure. Show the process on a P-v diagram

  A car moves along a straight line starting from rest with

a car moves along a straight line starting from rest with an acceleration of 5 fts2 for 6 seconds then brakes with a

  What is a beam

What is a beam? What factors determine the maximum load that it can take without failure?

  What is the magnitude and direction of the force that must

you are swinging your younger sister in a circle of radius .9m. if her mass is 24kg and you arrange it so she makes one

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd