Sketch how you will place the bars and calculate

Reference no: EM13545654

If you have to fit three number 10 bars and 2 number 8 bars in a rectangular beam of 12 inch width you may need to use two rows. Given;

beam is 24 inch deep, the steel stirrup used is number 4,a 1 1/2 inch.

concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.

Reference no: EM13545654

Questions Cloud

Determine the size of the watershed in acres and then : The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.

Determine the magnitude of the largest elastic load p that : The 10-mm-diameter steel bolt is surrounded by a bronze sleeve. the outer diameter of this sleeve is 20 mm, and its inner diameter is 10 mm. if the yield stress for the steel is

What is the maximum weight of the crate that the system can : Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of = 74.0 with the floor and rope segment CD

Find the capacity of the column with 1% reingforcement : A circulatr concrete column with a diameter of 8" has spiral reinforcing. Find the capacity of the column with 1% reingforcement. Find the capacity of the column with 8% reinforcement.

Sketch how you will place the bars and calculate : Concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.

Determine for each case the ration of the total energy : Consider two cases: (1) a constant wind velocity that is twice the mean wind velocity and operating half the time; and (2) a constant wind velocity that is three times the mean wind velocity operating one-third of the time. At all other times, the wi..

Design a one way slab to support a uniform live load : Design a one way slab to support a uniform live load of 300 psf. The beam is simply supported with a span of 20 ft. Use a reinforcement ration ( Ps) of 0.008 Use f'c=3000 psi and fy=60000 psi.

The angle measured counterclockwise between line ab and : The true azimuth of line AB is 193 degrees 20'. The angle measured counterclockwise between line AB and another line AC is 205 degrees 10'. The true azimuth of line AC is:

What is the elevation of point n : A leveling rod is held vertically on another point N. When a sight is taken on the rod, the telescope is inclined so that the horizontal cross line of the transit intersects the rod at a reading of 4.9 ft.

User Account

All Pages