Reference no: EM13313769
1. Simplify the default set of sources, vehicles and barriers presented to the user at startup to be just one source, one vehicle and one barrier; the source and barrier should be positioned so that the vehicle interacts with them in an interesting way, e.g., it orbits the source until it hits the barrier at which point it orbits in the other direction.
2. Change the set of vehicles listed in the "Add Vehicle" dropdown JComboBox to match those listed in Braitenberg's book, and update the help documentation to explain what these vehicles do. It should be possible to add instances of vehicle types 2a, 2b, 3a, 3b and 3c from Braitenberg's book, and each vehicle type should be a different colour. This will involve writing a new class for each vehicle type, but these should be a straightforward extension of the SimpleVehicle class or one of its subclasses.
3. Modify the drawing of a vehicle with a source attached so that it is clear that it has a source attached. For example, you could add a yellow shape to the rear of the vehicle to show that it has a light attached and a red shape to show that it has a heat source attached. It should be possible to attach a source to any vehicle type as at present.
4. Extend the editing of vehicles to allow editing of the weight (importance) of a sensor in determining the motion of the vehicle.
You should also note any bugs you fixed as part of implementing the requirements above (this is important!).
The source files are in the src folder, and the documentation of the files are in the documentation folder.
Attachment:- Assignment.zip
|
What is the drawdown halfway between well a and well b
: They each completely penetrate a homogeneous, confined aquifer, and pump at exactly the same rate, 5m^3/day. Prior to pumping, the piezometric head was 30m, the same as the thickness of the aquifer.
|
|
What is the stress within the column
: a marble column of a cross sectional area 1.5 m^2 suports a mass of 24000 kg, what is the stress within the ciolumn? N/m^2
|
|
How to make a preliminary selection of member size
: Using the tables in the AISC manual, make a preliminary selection of member size, using a HSS shape. Do not simple state a choice - state your logic step by step, quoting page numbers (AISC) for each step.
|
|
Compute the percentage of the principal basic component
: Calculate the percentage of the principal basic component in the sample (That is, the component that is present in the largest percentage. You will need to determine which species are present and calculate the mass percent for each of them in the ..
|
|
Simplify the default set of sources
: Extend the editing of vehicles to allow editing of the weight (importance) of a sensor in determining the motion of the vehicle.
|
|
What is the static pressure of the water at the outlet
: A PVC pipe has an inside diameter of 40 mm, is 30 m long and carries 10°C water at a rate of 3.5 m3/hr. At this rate, the friction factor of the pipe is 0.0814.
|
|
Calculate weight percent austenite and weight proeutectoid
: a .65% Carbon hypoeutectoid plain carbon steel is slowly cooled from 950 degrees C to just slighty above 723 degrees C calculate the weight percent austenite and weight proeutectoid ferrite in this steel
|
|
What was the speed of cue ball before and after collision
: A cue ball, which has a mass of 0.17 kg, collides head on with a stationary 8 ball, what was the speed of the cue ball before and after collision
|
|
Find method to compute the flexural stresses for the load
: Assume the section has cracked and use the transformed area method to compute their flexural stresses for the load. Given: Beam 30 ft long with uniform load of 2 k/ft and a point load of 30 k at 10 ft.
|