Shell-and-tube heat exchanger is used to cool flow of steam

Assignment Help Mechanical Engineering

Reference no: EM13711542

A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2). The mass flow rate of the steam is 2.6 Â· 105 kg/hour. The cooling water enters the heat exchanger at 5 MPa and 15oC (state 3) and exits at 38oC at the same pressure (state 4). The cooling water can be treated as an incompressible liquid. Neglect stray heat transfer and neglect kinetic and potential energy effects. As well, assume the system is operating under steady-state conditions.

a) Determine the mass flow rate of cooling water in kg/s.

b) Determine the rate of heat transfer between the steam and the cooling water in MW.

Reference no: EM13711542

Questions Cloud

Determine the average load current : Chopper circuit has the parameters of a source frequenCy of 150 Hz and an on time of 3 ms. vohage of 90 V, chopper When this chopper drives an inductive load of 1.5 0 and 15 mH, determine the average load current.

Maximum shear stress can be adequately approximated : The maximum torque produced by the engine of the car occurs at 4750 rpm, when the engine is generating 286 HP. The designer followed the following method and chosen steel shaft having yiled stress at 80,000 psi and a factor of safety = 4.

What is the gauge pressure in the container : A rigid adiabatic container in a room with a barometric pressure of 100 kPa is divided into two unequal volumes as shown. V1 = 0.108 m3 and contains air (R = 0.2870 kJ/kg-K, k = 1.40) at a gauge pressure of 32 kPa and temperature of -3Â°C.

What rate is heat rejected from this engine as waste heat : An engine burns 200 cubic feet per hour of natural gas with a heating value of 1000 btu/cubic feet. The engine produces 39.1 horsepower for this test. What is the average efficiency for this test? At what rate (btu/h) is heat rejected from this engin..

Shell-and-tube heat exchanger is used to cool flow of steam : A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2). The mass f..

Measure the horizontal distance lengths of traverse : Measure the horizontal distance lengths of traverse legs using pacing, surveyor's tape and total station - familiarise with the use of GPS to measure coordinates and other computations (i.e. Slope and horizontal distances, area, perimeters etc.)

What is its initial pressure : An airplane pilot is about to leave a long cross-country trip that will require him to use oxygen. He's noticed that the amount of oxygen in the bottle in the plane is low, so he must refill it from the large supply tank of oxygen in his hanger. The ..

Conduct the necessary marketing analysis for your strategy : Analyze the MARKETING ENVIRONMENT. The Marketing Environment is covered in a Powerpoint presentation provided - Briefly explain what you did and indicate the sources you have used.

User Account

All Pages