Round up to the nearsest millimeter when reporting

Assignment Help Mechanical Engineering

Reference no: EM13336839

An engineer determines that a 40 cm long rod of 1020 grade steel will be subjected to a tension of 20 kN. The following two designs requirements must be met. The stress must remain below 145 MPa, and the rod must stretch less than 0.125 mm. Determine an appropiate value for the rod's diamter to meet these two requirements. Round up to the nearsest millimeter when reporting your answer

Reference no: EM13336839

Questions Cloud

Difference between the body mass index values of men : How do you write a statistical analysis in which the emphasis is to compare the difference between the body mass index (BMI) values of men and women.

The city-highway mileage estimate : The EPA will grant a tax credit if the city-highway mileage estimate is at least 31 mpg

President of the student government at a large university : Candidate A is running for president of the student government at a large university.

A gasoline engine is modeled as an otto cycle : A gasoline engine is modeled as an Otto cycle. It has at temperature and pressure at the beginning of compression of 10°C and 90 kPa. The compression ratio is 7 and the specific energy added to the air during the heat addition process is 1432.46 ..

Round up to the nearsest millimeter when reporting : An engineer determines that a 40 cm long rod of 1020 grade steel will be subjected to a tension of 20 kN.

Determine the forces in ao, ab, and ac for equilibrium : The lamp has a mass of 15 kg and is supported by a pole AO and cables AB and AC. If the force in the pole acts along its axis, determine the forces in AO, AB, and AC for equilibrium.

The surface of the sea : An iceberg with specific gravity (SGice) of 0.92 is partially submerged in seawater whose specific gravity is SGw= 1.025. Determine the relative volume of the iceberg that appears above the surface of the sea.

Helium enters subsonically and flows isentropically : Helium enters subsonically and flows isentropically through the converging-diverging duct. Compare the values of Ma, T/T0, and P/P0 for helium with those for air at several locations in the duct. Use 0.163 ≤ Ma ≤ 3.221.

A company purchases a piece of manufacturing equipment : A company purchases a piece of manufacturing equipment for rental purposes.

User Account

All Pages