Rope bca passes through a pulley at point c and supports a

Assignment Help Mechanical Engineering

Reference no: EM13628941

Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of = 63.0 with the floor and rope segment CD creates an angle with the horizontal. If both ropes BCA and CD can support a maximum tensile force = 140 , what is the maximum weight of the crate that the system can support? What is the angle required for equilibrium?

Reference no: EM13628941

Questions Cloud

In a simple random sample of 80 automobiles registered in : in a simple random sample of 80 automobiles registered in jland 28 of them were found to have emission levels that

Its maximum altitude is h determine and plot the fraction : a projectile is launched from point a and lands on the same level at d. its maximum altitude is h. determine and plot

Assuming ideal-gas behavior for air steady flow and : air enters a compressor at 105 kpa and 300 k with a volumetric flow rate of 12 m3min and exits at 1200 kpa and 400 k.

A 015-m-diameter pulley turns a belt rotating the : a 0.15-m-diameter pulley turns a belt rotating the driveshaft of a power plant pump. the torque applied by the belt on

Rope bca passes through a pulley at point c and supports a : rope bca passes through a pulley at point c and supports a crate at point a. rope segment cd supports the pulley and is

Let test statistic t have a t distribution with df degrees : let test statistic t have a t distribution with df degrees of freedom.a as df gets larger what distribution does t

As a function of a what is the expected value for x as a : the following distribution is used in economicsx f x a a.x a-1 3a for 0 ? x ? 3 and a gt1 and 0 otherwisea as

Te r2nbspand adjusted r2nbsptell us how much of the : please provide clear explanationthe r2nbspand adjusted r2nbsptell us how much of the variation in the dependent

Knowing that es 200 gpa and ea 70 gpa determine a the : compressive centric forces of 160 kn are applied at both ends of the assembly shown by means of rigid plates. knowing

User Account

All Pages