Reference no: EM131877333

Quetion: 1. The given part just tell you what this project is and you don't have to worry about that. Just need to understand what is that and how does that work.

Design for Benchtop Point of Care Device

Point of care devices are mainly needed in locations where AC power may not be readily accessible therefore, the design will rely on (direct current) DC power. Our device will deliver a fully autonomous solution that will be controlled by an onboard controller and driven by a 12VDC motor with a max rpm of 1100 rpm. The motor speed will be monitored by an in-line encoder, this will allow the system to monitor and regulate speed of the motor. For testing purposes the device will require a heat source that will require a constant temperature of 60 degrees Celsius +/- 5 degrees Celsius for 20 minutes. The heat source will be an optical heating based source. A temperature sensor will be utilized to monitor and ensure compliance with temperature variation. As shown below in Figure 1, our benchtop device will assist in the diagnosis of disease based off of a chemical reaction that occurs in the disk detector chamber, an ultraviolet light source will be required for detection of chemical microfluidic reactions in the detection chamber. The casing of the device should have the durability to withstand any extreme weather condition.

2. Follow the revision requirements - small black words, below the blue words , to revise the blue words part. Add around 300 words revisions. The blue words parts are about testing of this project. It is already exist some of tests over there. Google search ASTM stuff and edit that. The part you add is test about temperature ASTM, Strobe light and Alumin light. Add 300 words in total.

Information related to above question is enclosed below:

Attachment:- NewMicrosoftWord.rar