Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Suppose there is a cylindrical shell with inner radius 'a' and outer radius 'b' inner surface is at potential V0 and outer surface is grounded. The area between inner and outer surface is filled with two dielectric materials (σ1,?1 for 0< Φ<2π/3 and σ2,?2 for 2π/3< Φ<2π ). If length of shell is L. Calculate Resistance per unit length using total power dissipation and power dissipation density.
Given the R-2R DAC unit with a 2-bit value defined as b1b0 = 01 shown in Figure 2.40, determine the converted voltage.
A battery is limited in the amount of current that it can supply to a load. When disconnected and fully charged, the voltage across the battery terminals is measured to be 13.8 V. When connected to a load that dissipates 18 W of power
discharge a capacitor of 1mF charged with a voltage of 1 volt we connect it, at time t = 0, with a esistor of R ohm. When we measure the voltage we find it to be V(r) (t) = e ^(-t) u(t). Determine the resistance of R. If the capacitor has a capaci..
What is the strength of the electric field at the position indicated by the dot - What is the direction of the electric field at the position indicated
the magnetic circuit shown in figure 1.17 has a mean core length of 52 cm and a cross-sectional area of 18 cm2. the
A line charge with density 2nC/m exists at y= -2, x=0. Find the electric field intensity at the origin. Now we wish to place a point charge Q=8nC at such a point so that the total electric field is zero at the origin. Determine the location of the..
The transistor parameters in the CMOS inverter are VTN = 0.35 V, - Determine the peak current in the inverter during a switching cycle for (W/L)n = 2 and (W/L)p = 4.
In a circuit, there is a resister, a conductor and a capacitor connected to voltage source. R = 25 ohms, L = 20 milliH, and C = 50 microF. a) Find the total impedance of the network if the frequency is 60 Hz.
A large brass washer has a 2-cm inside diameter, a 5-cm outside diameter, and is 0.5 cm thick. Its conductivity is s = 1.5 × 107 S/m. The washer is cut in half along a diameter, and a voltage is applied between the two rectangular faces of one par..
A somewhat discharged automotive battery has an open-curcuit voltage of 12.5 V and supplies 50 A when a 0.1 ohm resistance is connected across the battery terminals.
A sample has a T1 of 0.8 seconds. The net magnetization from the sample set equal to zero and then allowed to recover towards its equilibrium value. After 1.0 seconds, what fraction of the equilibrium magnetization value will be present
Different between automatic iron and non automatic iron
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd