User Account

All Pages

Rc circuits in multisim

Assignment Help Other Engineering
Reference no: EM131081388

RC Circuits in Multisim

This week's lab is based on the application of circuit analysis techniques to evaluate an RC circuit in Multisim.

  1. Watch video lecture entitled "Week 4 - RC Circuit in Multisim".
  2. Work Practice Problem 8.13 from Chapter 8 to determine the capacitor voltage 'V' for t >0 and record the value in the table.
 

Calculated

Measured

Capacitor Voltage 'V'

    
  1. Construct Figure 8.46 from Chapter 8 in Multisim.
    1. Run simulation to measure the voltage across the capacitor 'V' (Use 5% tolerances for each of the resistors)
    2. Take the screen capture for the measurements for 'V'.
  2. Answer the following questions:
    1. Are the measured values same as calculated values? If not, explain why they are different?
    2. What is the circuit time constant 'τ'?
    3. Is 'V' a natural, forced or complete response? Explain why?
  3. Create a new word document called "Lab4_StudentID.docx" with your GID substituted into the file name.
  4. Save the analysis from step 2 and simulation results from step 3 along with the table and screen captures of all the measurements. Make sure to answer the questions in step 4.
  5. Upload file "Lab4_StudentID".

Reference no: EM131081388

Questions Cloud

Voltage and current laws in multisim : This week's lab introduces you to the construction of a resistive network in Multisim. You will learn to utilize Multisim to confirm your calculations.
Number summary for data for all five departments : Find the five number summary for the data for all five departments. Consider all five departments as one department.
Capacitive circuits in multisim : Watch the video lecture entitled "Week 3 - Capacitor Op-Amp Circuit in Multisim. Construct Figure 7.36 in Chapter 7 (Example 7.11) with Vs = 3sin200tV, R1=20kohms, Cf=5uF, and Vc(0) = 1.5 and find the output voltage 'Vout'.
Find equilibrium constant for dimerization of acid in vapour : The experiment was repeated with the same container but at 471 K, and it was found that 0.0380 g of acetic acid was present. Calculate the equilibrium constant for the dimerization of the acid in the vapour and the enthalpy of vaporization.
Rc circuits in multisim : Watch video lecture entitled "Week 4 - RC Circuit in Multisim". Work Practice Problem 8.13 from Chapter 8 to determine the capacitor voltage 'V' for t >0 and record the value in the table.
Identify key assumptions regarding financial projections : Identify key assumptions and conclusions regarding financial projections. Present data in a professional manner with headings and meaningful number formatting.
Explain the relationship between risk and return : Explain the relationship between risk and return? Identify an example of risk and return. Explain which is more risky bonds or common stock Explain how understanding risk and return will help you in future businessventures.
Laplace transform and analysis in s-domain : This week's lab is based on the application of circuit analysis techniques to a capacitive circuit with Multisim. You will learn to utilize Multisim to perform the mesh analysis.
Does idea for entrepreneurial firm fall into category social : Review the interview between Charlie Rose and Jack Ma. Extract and interpret the dynamics most important to becoming a successful global entrepreneur. Explain how these might reflect (or not) on your own current visions about your potential busine..

Reviews

Write a Review

Other Engineering Questions & Answers

  Explain magnetic fluid is required for the application

Make a table assuming 10 g of magnetic fluid is required for the application or end use. In the table give the the cost per fluid using each of the three options and the volume fractions. Then report on the maximum viscosity, minimum cost, and opt..

  Find angle between the birds velocity vector and horizontal

Find the angle between the birds velocity vector and the horizontal - Assume a bird completes a circle of radius 6.00m every 5.00s and rises vertically at a rate of 3.00m/s.

  Estimate the value of the overdrive voltage

A two-stage CMOS op amp resembling that in Fig. is found to have a slew rate of 60 V/μs and a unity-gain bandwidth ft of 60 MHz. Estimate the value of the overdrive voltage at which the input-stage transistors are operating.

  What is the expected error in the stage gain

In the quiescent state, what dc voltage must appear at the output of each of the error amplifiers? At what value of positive vO will QP be supplying all the load current? Repeat for negative vO and QN supplying all the load current.

  What is strategic management and what are some of its major

What is strategic management and what are some of its major objectives? Explain in two paragraphs.

  Problem regarding the downward force

If the pressure inside is 1.0 atm, what downward force must the crew exert on the hatch to open it?

  Gas refrigeration system using air

A gas refrigeration system using air as the working fluid has a pressure ratio of 5. Air enters the compressor at 0°C. The high-pressure air is cooled to 35°C by rejecting heat to the surroundings. The refrigerant leaves the turbine at -80°C and t..

  Create a timeline illustrating the major milestones

Create a timeline illustrating the major milestones of the telecommunications industry, including networking and voice, using Microsoft Word, PowerPoint, or Excel

  Henry clements car rental agency case study

How many cars will need to be moved and what will the total cost of the move be?

  Draw a state graph for the control circuit

Draw a block diagram for a parallel divider that is capable of dividing a positive 6-bit binary number by a positive 4-bit binary number to give a 2-bit quotient. Use a dividend register, a divisor register, a subtracter-comparator block, and a co..

  Calculate the number of multiply-and-add operations

Calculate the number of multiply-and-add operations the processor can use to work out the numerical value of each output sample of the digital filter and from this deduce the maximum filter order that can be implemented. Explain your logic clearly.

  The independent samples t-test, in statistics for managers

How does variability in the distribution of sample means compare to variability in a population based on individual scores?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd