Provide an appropriate digital output to a computer

Assignment Help Electrical Engineering

Reference no: EM131392611

A calibrated RTD with

α = 0.0041 / °C, R = 306.5 Ω at 20 °C, and P_D = 30 mW/°C

will be used to measure a critical reaction temperature. Temperature must be measured between and with a resolution of at least 0.1°C.

Devise a signal-conditioning system that will provide an appropriate digital output to a computer. Specify the requirements on the ADC and appropriate analog signal conditioning to interface to your ADC.

Reference no: EM131392611

Questions Cloud

Design a cam to drive an automotive valve train : The open-close event occupies 160° of camshaft revolution; dwell for remainder. Use one or two polynomials for the rise-fall event. Select a spring constant and preload to avoid jump to 3500 rpm. Fast opening and closing and maximum open time are ..

Describe the public health issues associated : Clean water and sanitation are essential to the functioning of any city. Choose two cities from different historical periods, describe the public health issues associated with water/sanitation in those specific cities, and compare them to similar pro..

Devise a system that will convert the temperature range : Devise a system that will convert this temperature range into an 8-bit digital word with conversion from 00H to 01H at and the change from FEH to FFH occurring at 350°C. An ADC is available with a 2.500-V internal reference.

Develop the complete circuit : A three-terminal solid-state sensor with will be used to provide reference compensation. Develop the complete circuit.

Provide an appropriate digital output to a computer : Devise a signal-conditioning system that will provide an appropriate digital output to a computer. Specify the requirements on the ADC and appropriate analog signal conditioning to interface to your ADC.

Find the follower force over one revolution : Repeat Problem 15-12 using a cam with a 20-mm symmetric double harmonic rise and fall (180° rise -180° fall). See Chapter 8 for cam formulas.

Fully loaned up and they face the same reserve ratio : Suppose all other banks in the system are “fully loaned up” and they face the same reserve ratio. The maximum potential increase in the money supply is._____ . If the Fed were to change the rr to 10% for this bank then.

Find the arm mass and center of gravity location : Cam speed is 200 rpm. Choose a suitable r spring rate and preload to maintain follower contact. Select a spring from Appendix D. Assume a damping ratio of0.15.

Determine how many thermocouples are required : Determine how many thermocouples are required and how they are distributed on the wings. Be sure to consider the internal resistance of the thermocouples.

User Account

All Pages