Property for given state and show on stated state diagram

Assignment Help Mechanical Engineering

Reference no: EM13710391

Determine the property for the given state and show on stated state diagram:

a) Water, T= 26 C and h = 2500 kJ/kg; find v [m3/kg]; and show on P-v diagram.

b) R-22, T = -18 C and P = 3.0733 bars; find u [kJ/kg]; and show on T-v diagram.

c) R-134a, P = 180 psia and v = 0.34567 ft3/lbm; find T [F]; and show on T-v diagram.

d) Air, T = 743 R and P = 40 psia; find v [ft3/lbm] and u [Btu/lbm]; and show on P-v diagram.

Reference no: EM13710391

Questions Cloud

Calculate the average velocity in each section : Air at 60° F and 40 psia is flowing in a 4" diameter pipe at 0.2 slugs/sec. The pipe undergoes a conversion to a 2" by 3" rectangular duct in which T = 150°F and P = 7 psia. Calculate the average velocity in each section.

Calculate the fugacity of liquid hydrogen sulfide : Calculate the fugacity of liquid hydrogen sulfide in contact with its saturated vapor at 25.5C and 20 bar. The vapor pressure of pure water at 310.6 K is 6.455 kPa. Compute the fugacity of pure liquid water at 310.6 K when it is under a pressure of 1..

Liquid-vapor water mixture in a rigid tank : Â½ kg of a liquid-vapor water mixture in a rigid tank initially at 2 bar is heated by 120V heater for 5 minutes until it becomes a saturated vapor at 4 bar. Changes in kinetic and potential energies can be ignored.

Determine the heat transfer and work transfer : Ten pounds-mass of R-22 is at an initial volume of 4.059 ft3 and pressure of 200 psia. It is compressed isobaric ally until its volume is two-thirds of its initial volume. The piston is then held in place as the refrigerant cools until its temperatur..

Property for given state and show on stated state diagram : Determine the property for the given state and show on stated state diagram:

Head space under slight vacuum-piped to natural gas boiler : 100 kmol/h of biogas (75 mol% CH4 and 25 mol% CO2) is produced in a digester and is drawn off from the headspace under a slight vacuum and piped to a natural gas burning boiler. A slight leak develops in the pipe allowing air (79 mol% N2 and 21 mol% ..

Boundary conditions for both the pipe and the insulation : Write the appropriate form of the heat equation along with reasonable boundary conditions for both the pipe and the insulation.

Determine net work output and thermal efficiency : A Rankine cycle with reheat operates between 20 kpa & 12.5 Mpa with a reheat occurring at 1.2Mpa. Steam enters both the high and low pressure turbine at 500 C, and the enthalpy of steam at the exit of high and low pressure turbines are 3050 and 2600 ..

The extrusion ratio-die geometry and extrusion speed : The extrusion ratio, die geometry, extrusion speed, and billet temperature all affect the extrusion pressure. Explain why.

User Account

All Pages