Proper diameter pipe, the nearest to get design objective

Assignment Help Physics

Reference no: EM1311264

An engineer is tasked with designing a pump station to convey wastewater at a flow rate of 250 m3/hr, to an equalization tank. A velocity of at least 3 ft/s must be maintained in the pipe to prevent deposition and provide scouring of any previously-deposited solids. However, a maximum velocity of 10 ft/s is prescribed to prevent over sizing the pumps. Due to the nature of the wastewater, the engineer wants to target the high end of this range. Find the proper diameter pipe to the nearest 2” (e.g., 2”, 4”, 6”, 8”, 10”, etc.) to achieve this design objective. Give answer.

Reference no: EM1311264

Questions Cloud

Probabilities of low-medium and high compliance : The probabilities of low, medium and high compliance are 0.3, 0.4, and 0.3, respectively

Find the change in water surface height in the cone : A 90° inverted cone contains water as shown. The volume of the water in the cone is given by V = (p/3) h3. The original depth of the water is 10 cm. A block with a volume of 200 cm3 and a specific gravity of 0.6 is floated in the water. Find the c..

Calculate the amount of water discharged : Calculate the discharge in cubic meters per second and in cubic feet per second if A pipe with 2m diameter carries water having a velocity of 4 m/s.

Mass flow rate of the water discharged from a pipe : A pipe with a 2m diameter carries water having a velocity of 4 m/s. What is the mass flow rate of the water in kg/s at the following temperatures.

Proper diameter pipe, the nearest to get design objective : Due to the nature of the wastewater, the engineer wants to target the high end of this range. Find the proper diameter pipe to the nearest 2” (e.g., 2”, 4”, 6”, 8”, 10”, etc.) to achieve this design objective.

Calculate the force that can be resisted by a piston : If a 200 N force F1 is applied to the piston with the 4 cm diameter, Calculate the magnitude of the force F2 that can be resisted by the piston with the 10 cm diameter? Ignore the weights of the pistons.

Determine the force of the gate on the block : Some skin divers go as deep as 50 m. What is the gage pressure at this depth in fresh water, and what is the ratio of absolute pressure at this depth to normal atmospheric pressure.

Calculate necessary force open a wide gate : Calculate P necessary to just start opening the 2 m wide gate.

Find the minimum volume of concrete : Find the minimum volume of concrete (y = 23.6 kN/m3) needed to keep the gate (1 m wide) in a closed position; l = 2 m. Note the hinge at the bottom of the gate. Explain briefly.

User Account

All Pages