Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Simulate the following circuit on PSpice showing the capacitor current and capacitor voltage during the transient phase. Use the following component values in the circuit: L = 1 mH, C = 1.57 μF. In your simulation calculate the resistor values in order to produce critically damped, overdamped, slightly underdamped, and very underdamped circuits.
2. Show, with calculations, how Laplace transforms can be applied to the transient analysis in the above circuit. Compare your simulated and calculated results.
3. Replace the 20 V a.c. supply in the circuit above with a step volt supply and analyse the circuit (show and comment on the capacitor voltage and current).
How long in time must the pressure pulse be to allow for a detonation to occur and what is the minimum distance that the shock must traverse to allow for a detonation to occur?
Air at 22 kPa, 220K and 250 m/s enters a turbojet engine in flight at an altitude of 10,000m. The diffusor slows the air down to a very low speed relative to its inlet. The pressure ratio across the compressor is 12. The turbine inlet temperature is ..
a 70 kg boy stands on the edge of a stationary 100 kg platform the platform is on frictionless rollers. suddenly he
when deciding what propulsion system is most appropriate for a mission thrust and isp are not the only parameters that
steam is the working fluid in an ideal reheat rankine cycle. steam enters the first-stage turbine at 8.0 mpa 480oc and
the pressure drop between the entrance and exit of a 150 mm diameter 90deg elbow through which ethyl alcohol at 20degc
Calculate the number of vacancies per cubic meter in some metal at 763°C. The energy for vacancy formation is 0.79 eV/atom, while the density and atomic weight for this metal are 4.77 g/cm3 and 88.45 g/mol, respectively.
A mass of 0.5 g of air is contained in a piston-cylinder device. Initially the system is at 100 kPa and 25°C. The system is now compressed adiabatically to a volume 17 times smaller and a temperature of 700 K.
find a unique four-bar mechanism one that was not mentioned in class like the vise grips. sketch the mechanism and
a 3 cm diameter bar 3 m long is attached to two walls on either end of the bar. the walls are at a temperature of 100
air at 14.7 psia and 60 degf enters a heavy duty compressor with negligibly small inlet speed. the air is discharge at
A compressor receives 0.1 kg/s R-134a at 150 kPa, -10C and delivers it at 1000 kPa, 40C. The power input is measured to be 3 kW. The compressor has heat transfer to air at 100 kPa coming in at 20C and leaving at 30C (i.e. like a heat exchanger). What..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd