Presuming that ideal filters are available

Assignment Help Electrical Engineering
Reference no: EM13138956

Analysis of digitally sampled PCM audio signal
An audio signal has a frequency range from 50 Hz to 20 kHz. The signal is sampled, digitized and recorded on magnetic tape as a PCM signal.

a. Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?

b. The audio signal is sampled at a frequency of 50 kHz and converted to a serial bit stream using a 12 bit analog to digital converter (ADC). What is the bit rate of the digital signal that is recorded on the magnetic tape?

c. When the analog signal is recovered, aliasing can occur if the low pass filter in the receiver is not correct. What specific criterion must the low pass filter meet to avoid aliasing?

d. The digital signal is replayed on a magnetic tape player and converted back to an analog signal using a digital to analog converter. What is the quantization signal to noise ratio (SNR) of the analog signal?

Reference no: EM13138956

Questions Cloud

What total size sample necessary to find true proportion : What total size sample would be necessary if we wanted to estimate the true proportion to within ±0.08 using 90% confidence?
Evidence on scientific discovery and business planning : Explanation of the impact of evidence on scientific discovery and business planning is an in depth analysis, including at least two well documented examples.
England revival and missionaries : What were the circumstances that contributed to the rise of the Wesleyan Revival in England, in life of the rampant growth of Enlightenment relative to 18th century England.
What type of loss carries over to 2012 : The chart below describes the § 1231 assets sold by the Tan Company (a sole proprietorship) this year. Compute the gain or loss from each asset disposition and determine the net § 1231 gain treated as long-term capital gain for the year. Assume th..
Presuming that ideal filters are available : Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?
What is the atomic mass of this element : Isotope 1 has a mass of 120.9038 amu and a relative abundance of 57.4%, and isotope 2 has a mass of 122.9041 amu. What is the atomic mass of this element?
Communication between a manager and an employee : Communication between a manager and an employee can sometimes be distorted. Do you agree/disagree or take middle position? Argue in support of your stance.
What is consolidated cost of goods sold : A total of 35 percent of this inventory was not sold to outsiders until 2013. In 2012, Bellgrade reported cost of goods of $380,000 while Hansen reported $210,000 What is consolidated cost of goods sold in 2010?
Wha are the principles of health and wellness : wha are the principles of health and wellness

Reviews

Write a Review

Electrical Engineering Questions & Answers

  The design must show all stages used in its development

The design must show all stages used in its development and must be implemented and tested in PSpice and suitable timing waveforms produced.

  Explain the critical radius of insulation.

Explain the following terms; (i) critical radius of insulation. (ii) economic lagging thickness.

  Electronics for recording

Transmit this data wirelessly to a base station for storage. How much bandwidth would you need.

  Define the river estuary is tidal causing the surface

The river estuary is tidal causing the surface level of the water to rise and fall. At certain times of day, reflections from the water surface cause deep fading of the received signal.

  Explain how an electric shock may occur

A process worker received an electric shock when she attempted to turn off a conveyer control. The toggle switch controlled the power to a variable speed drive. An examination found that dust had accumulated on the toggle switch. Moisture on the ..

  What is the requirement for the phase response transfer

What is the requirement for the phase response (transfer function) of each of these links to avoid distortion of the transmitted waveform?

  Define dsss-cdma chip sequence

A DSSS-CDMA signal has a chip sequence that is 1,000 chips in length. The sequence repeats every millisecond. Define DSSS-CDMA Chip Sequence

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Create a program using asmide

Create a program using AsmIDE, which utilizes the Fox 11 68HC11 microcontroller board: Speech timer where max time is 5 minutes Use the switches for:

  Define design bandpass filter of ''sallen and key'' topology

Design a bandpass filter of 'Sallen and Key' topology and having the following characteristics fo = 3.3 kHz, Q = 2.2

  Define in comparing the behaviour of an n-channel mosfet

In comparing the behaviour of an n-channel MOSFET with a p-channel device having identical geometry and threshold voltage, it is found that the n-channel FET has a greater drain current than that of the p-channel FET.

  What is the symbol rate and what is the bandwidth

What is the symbol rate and what is the bandwidth occupied by the 16-QAM signal? The link must maintain a BER no higher than 10^-6. What is the minimum CNR in the receiver to meet this requirement?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd