Pole-vaulter is holding the vaulting pole parallel

Assignment Help Mechanical Engineering
Reference no: EM13719890

A pole-vaulter is holding the vaulting pole parallel to the ground. the pole is 5 m long. The vaulter grips the pole with his right hand at the top end of the pole and with his left hand 1 m from the top end of the pole. the mass of the pole is 2.5 kg, the forces of the vaulter must excert on the pole to maintain it in this position are quite large. how large are they? (Assume the vulter excerpts only vertical forces on the horizontal pole and that the center of gravity of the pole is located at the center of its length)

Reference no: EM13719890

Questions Cloud

Using the average-end area-method : Determine the quantity of asphalt and granular material required for the parking lot. The asphalt is 4 inches thick and granular material is 8 inches thick.
What is the pressure that the pump can deliver : 4 kW motor is driving an oil pump with an efficiency of 95% in a 10 mm diameter pipe. If the velocities of the fluid in the pipe is 1.8 m/s. What is the flow rate that the pump delivers?
Moles of the endo conformer are present in the effluent : Cyclopentadiene and cyclohexanone are combined in a reactor and undergo an addition reaction.  The adduct can either have an endo or exo conformation.  For the application your plant has only the endo conformation is desired.
How many pump stations would be needed for a pipeline : 200mm DN pipeline has to deliver 80m³/h of water at a discharge pressure of  5,550 kPa. Approximately how many pump stations would be needed for a pipeline 300km long?
Pole-vaulter is holding the vaulting pole parallel : A pole-vaulter is holding the vaulting pole parallel to the ground. the pole is 5 m long. The vaulter grips the pole with his right hand at the top end of the pole and with his left hand 1 m from the top end of the pole. the mass of the pole is 2.5 k..
Find the frequency of the radiation of maximum intensity : The walls of a blackbody cavity are at a temperature of 27oC. What is the frequency of the radiation of maximum intensity
A closed system consists of an ideal gas : A closed system consists of an ideal gas with constant specific heats that remain constant. The gas undergoes a process in which the temperature increases from T1 to T2.
The power developed by the turbine : A gas turbine has a mixture of 17% CO2 , 60% N2 and 17% H2O on a molar basis enter at 1800°R and 116 psi and a mass flow rate of 4.41 lbm/s. The gas expands through the turbine isentropic ally to a pressure of 14.7 psi and a temperature of 1112.4°R.
Amagots law and the generalized compressibility chart : A rigid tank contains 2 kmol of N2 and 6 kmol of CH4 gases at 200 K and 12 MPa. Estimate the volume of the tank using Amagot’s Law and the generalized compressibility chart

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Use 3 terms of taylor series to estimate the velocity at

the velocity of falling parachute is computed asvtgmc 1-e-cmtwhere g9.8ms2 m50kg c12.5.use 3 terms of taylor series to

  Determine the final gauge pressure of the helium given the

a tank contains helium at 103degrees celcius and 10.9kpa gauge . the helium is heated in a process by heat transfer

  Calculate the energy of the piston as it contacts the water

a water cannon for rock tunneling operates by using compressed gas for accelerating a 65-kg high-strength titanium

  Calculate the nusselt number and the convective heat

calculate the nusselt number and the convective heat transfer coefficient for water at a bulk temperature of 32oc

  Consider the equilibrium reaction in a closed vessel

Assume the vessel contains 1 mole of O2when there is no dissociation. Calculate mole fraction of O2 and O for the following conditions. Comment on how pressure and temperature impacts equilibrium composition and if the changes are consistent with Pri..

  Longitudinal strain on the upper and lower surfaces of bone

For studying the effects of mechanical loading on the bone, a diaphys is isolated as shown in the Figure. Pins extended from the metal caps over the bone ends. Assume a load is applied between the ends of the pins as shown.

  A horizontal circular cylinder of diameter d 02m and

a horizontal circular cylinder of diameter d 0.2m and length 2m is elastically mounted on two springs and towing tank

  Determine the moment around the front axel m-while thrusting

The rocket car below is thrusting so that at constant thrust (force) , it reaches a velocity of 500 km/hr in 30 seconds. How much thrust is this (kN)? Determine the moment around the front axel M, while thrusting.

  Determine the recoil velocity of the gun

An old 3000-lb gun fires an 18-lb shell with an initial velocity of V0=1500ft/s at an angle of 30 degrees. The gun rest on a horizontal surface and is free to move horizontally. Assuming that the varrel of the gun is rigidly attached to the frame and..

  Determine the distance between a and b after 3 minutes

two ships a amp b are moving at constant velocities. at t0 the position of ship a is 2.41 miles east and 3.14 miles

  Convert the composition of the following alloy from atom

convert the composition of the following alloy from atom percent to weight percent a 44.8 at of silver b 46.3 at of

  Estimate the speed of the plane-assuming incompressible flow

An airplane flies at an elevation of 20,000 ft, where the atmospheric pressure is 45 kPa and the temperature is -24 °C. A pitot-static tube mounted on the plane in the free-stream gives a differential manometer reading equivalent to 8.5 inches of H2O..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd