Plot the ground level concentration of sulfur dioxide

Assignment Help Civil Engineering
Reference no: EM13555048

Power plant burns 150,000 tonnes (1 tonne = 1,000 kg) of coal each year. The coal has a 2.5% sulfur content, and the air pollution control equipment removals approximately 94% of sulfur. Assume 10% of the sulfur content ends up in the ash. The remaining combustion products are discharged through an 80 m stack with a diameter of 3.0 m. The stack off gas temperature and velocity are 320 oC and 4 m/s, respectively, and the atmospheric conditions are 102 kPa and 25 oC. If the atmospheric conditions are slightly unstable (Class C) and the wind velocity at 10 m elevation is 3.5 m/s:

1. Plot the ground level concentration of sulfur dioxide as a function of distance from the stack and determine the maximum ground level concentration at both with and without air pollution control and the distance from the stack where the maximum concentration occurs.

2. With air pollution control equipment in place, plot the contours for a ground level concentration that is half and ¼ of the maximum value and indicate on your plot the location of the stack and the location of the point where the maximum ground level concentration would occur.

Reference no: EM13555048

Questions Cloud

What is the lowest frequency produced by the organ pipe : An organ pipe open at one end has a length of 60 cm. If the speed of sound in air is 340 m/s, what is the lowest frequency produced by the organ pipe
What is the longitudinal strain under this load : A 4 meter long steel plate with a rectangular cross section (10mm x 50mm) is resting on a frictionless surface under the sun. The plate temperature is measured to be at 40 degrees Celsius.
How large must be the tank volume : Neon gas at 50 degrees C in a vertical cylinder of diameter 150 mm has a 6 kg frictionless piston mounted. The outside pressure is 98kPa and the neon volume is 4000cm^3. Find the mass of neon.
What type of system would you classify an electric wire : A system consists of a gas confined between a cylinder and piston such that work and heat may cross the boundary. What type of system is that? What type of system is a free body as used in mechanics or civil engineering? What type of system would you..
Plot the ground level concentration of sulfur dioxide : With air pollution control equipment in place, plot the contours for a ground level concentration that is half and ¼ of the maximum value and indicate on your plot the location of the stack and the location of the point where the maximum ground level..
Calculate the atmospheric pressure head : A barometer filed with non-toxic glycerin is used to measure standard sea level atmospheric pressure. neglecting the effect vapor pressure and surface tension. calculate the atmospheric pressure head.
How many days will it take for 90 per- cent of the chemical : How long will it take for 99 percent of the chemical to be destroyed? (c) How long will it take for 99.9 percent of the chemical to be destroyed?
What is the length of shrinkage : A meter long steel plate with a rectangular cross section(10mm x 50mm) is resting on a frictionless surface under the sun.the plate temperature is measures to be at 40C.the plate is then moved into a cold room and is left to rest on a frictionless su..
How many revolutions did the disc make during this time : a spinning disc rotating at 130 rev/min slows and stops 31 s later. how many revolutions did the disc make during this time

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the reaction force at the joint

an operator is holding a tool for a horizontal drilling task. the woman's elbow is flexed 45 degrees. The length of her forearm is 0.4m and the drill has mass of 5kg. Her forearm/hand weighs 20N and its center of mass

  Determine the required shaker frequency to cause resonance

A floor slab has a fundamental bending frequency of 10Hz. A shaker is placed at the centre of the slab for a dynamic testing. The tests confirm that the slab displays a damping ratio of 2% of critical.

  Design the ramp for the highest horizontal curve

The entrance to Mt. Hood Meadows (elevation 3,075 ft at the point of crossing) is grade separated from Viking highway (elevation 3,050 ft at the point of crossing) and will have to be connected. The two roadways intersect at a right angle.

  Determine max temperature rise in celcius degress allowed

The tank material is such that it can withsatand tension caused by a volume expansion of 2%. Determine the max temperature rise in Celcius degress allowed without jeopardizing safety.

  What is the probability of 2 or more such floods in 10 years

A hydrologic structure (e.g. a dam or a dike) is said to be designed for the N-year flood if it has a capacity which will be exceeded only by a flood equal oto or greater than N-year flood.

  Determine the tension in the cable

Determine the tension in the cable as the box moves between A and C and determine normal and tangential force components the road exerts on the car at this instant.

  What is the oil flowrate in stb

Two wells had been drilled on 40-acre spacing. Well 1 is injectionand Well 2 is producing well. Downhole injection pressure is 8500psi, and bottomhole pressure in producing well is 2400 psi.

  Determine the runoff hydrograph that would be generated

Determine the runoff hydrograph that would be generated by a design 3-hr storm that generates excess rainfall at a constant rate of 10 mm/hr. assume baseflow is constant at 1.0 m3/s.

  Which compressor should he buy and why

A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the s..

  How to design for a cultivated land with sandy loam soil

The bund channel is to be formed by the embankment only. The horizontal distance between two bund s is 50 m. The 1-hr rainfall expected during the recurrence interval of 10 yrs is 8 cm/hr.

  Determine the maximum height the projectile will reach

A projectile is fired up into the air at a speed of 161 m/s at an angle of 64° relative to the horizontal. Determine the maximum height the projectile will reach.

  What is the corrected length of the line

A 100ft tape is calibrated at 68 degrees F, fully supported with 15 Ibs of tension and found to be 99.987 ft long. Is this tape is used fully supported with 15 Ibs of tension at 86 degrees F to measure a distance that is recorded as 136.48 ft,?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd