Piston cylinder device contains

Assignment Help Mechanical Engineering
Reference no: EM13701074

A piston cylinder device contains .733 kg of refrigerant-134a at -10 degrees C. The piston that is free to move has a mass of 8.63 kg and a diameter of 21.2 cm. The local atmospheric pessure is 88 kPa. Now, heat is transferred to the refridgerant-134 until the temperature is 15 degrees C.

Determine:

a) The final pressure in kPa (round to 1 decimal place)

b) The change in volume of the cylinder in m^3 (round to four decimal places)

c) The change in enthalpy of the refridgerant-134a in kJ (round to 1 decimal place)

Please give clear answers.

Reference no: EM13701074

Questions Cloud

Assuming complete combustion and constant specific heats : Calculate adiabatic flame temperature butane (C4H10) burning in air at 298 k and 1 atm, assuming complete combustion and constant specific heats
What is the local heat transfer coefficient : Air at a pressure of 1 ATM, a temperature of 15° C, and a velocity of 10 m/s flows over a 3 m long flat plate that is heated to a uniform temperature of 140° C. What is the local heat transfer coefficient 3m from the leading edge of the plate?
Calculate the average temperature of the plate surface : Air at atmospheric pressure and a temperature of 25°C is in parallel flow at a velocity of 5 m/s over a 1m long flat plate that is heated with a uniform heat flux of 1250 W/m2. Assume the flow is fully turbulent over the length of the plate.
Fluid is ethylene glycol under the same flow conditions : For a laminar boundary layer flow over a flat plate with air at 20°C and 1atm, the thermal boundary layer thickness Dt is approximately 13% larger than the velocity boundary layer thickness D. Determine the ratio D/Dt if the fluid is ethylene glycol ..
Piston cylinder device contains : A piston cylinder device contains .733 kg of refrigerant-134a at -10 degrees C. The piston that is free to move has a mass of 8.63 kg and a diameter of 21.2 cm. The local atmospheric pessure is 88 kPa. Now, heat is transferred to the refridgerant-134..
How many times can he jump on his bed before beam breaks : After one particularly wild night at the bars, Jon decides to come home and jump on his bed .Assume that he's jumping directly in between one steel support beam that's 10 foot long, 2 inches wide and 1 inch thick. Further assume that Jon weighs aroun..
What is tension in swing cable developed during the motion : A gentry structure, similar to a tire swing, is used to test the response of an airplane is hoisted back until the 20m swing cable is at theta=60. Determine the speed of the plane just before crashing into the ground at theta=15, when released from r..
Determine the maximum power supplied by the engine : A sports car has a mass of 2000 kg and an engine running at an efficiency of 0.63, as it moves forward with a constant velocity of v=50 m/s,the wind creates a drag resistance on the car of FD=1.2v^ newtons. Determine the maximum power supplied by the..
Coefficient of kinetic friction between the wheels and road : A 3500 Ib. automobile is traveling down a 10 incline a 20 ft/./s. if the driver slams the break, causing the wheels to lock , determine how far the tires slide. the coefficient of kinetic friction between the wheels and the road is uk=0.5

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the angle beta between the horizontal and the

a rocket is tracked by radar from its launching point a. when it is 10 seconds into its flight the following radar

  Determine the surface temperature tb in k for this one i

an electric motor operating at steady state draws a current of 10amps with a voltage of 220v. the output shaft power

  Consider an investment in a project having a first cost of

consider an investment in a project having a first cost of 500000 operating and maintenance costs of 35000 per year a

  If the velocity out the 2-cm-diameter tube is 15 ms

water flows into a volume that contains a sponge with a flow rate of 0.02 m3s. it exits the volume through two tubes

  Determine the wall thickness of the hollow square rod for

two brass rods used as compression members each of 6-ft effective length have the the same cross sections.theround rod

  A special high pressure u-tube manometer is constructed to

a special high pressure u-tube manometer is constructed to measure pressure differential in air at 13.8mpa and 20 c

  Solve for the dynamics of the resulting system

Solve for the dynamics of the resulting system for 20 seconds of real time using midpoint method.

  During a cold day it is observed that the appliances all

a room contains 75 kg of air at 100 kpa and 15 deg c. the room has a 250 w refrigerator a 120 w television a 1.8 kw

  A flow is described by velocity field where a 02 s-1 and

a flow is described by velocity field where a 0.2 s-1 and b 0.4 ms2. at t 2 s what are the coordinates of particles

  Calculate the required heat transfer to or from the reactor

it is highly desirable to make benzene from ethane from shale gas in a continious vapor-phase reaction3c2h6 --gt c6h6

  1 steam is contained in a closed rigid container with a

1. steam is contained in a closed rigid container with a volume of 1 m3. initially the pressure and temperature of the

  Calculate the ratio of the exit flow area to the inlet flow

air enters an insulated diffuser operating at steady state with a pressure of 105 nm2 and a temperature of 57 degrees

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd