Obtain the half-range cosine series for the function

Assignment Help Mechanical Engineering

Reference no: EM13710396

A periodic function f(t)is of period 10 defined by f(t)=N+t2, 0<t<5, f(t+10)= f(t) where N, represents the last digit of your student number. (N is 8 ) Obtain the half-range cosine series for the function in this range.

Reference no: EM13710396

Questions Cloud

In a specific type of heat exchanger : In a specific type of heat exchanger, a very hot jet of air is cooled from 145 degrees centigrade to 100 degrees centigrade by a cold stream of water. The water temperature must not rise By more than 12 degrees centigrade. Find 1.

What is the polytropic exponent of this process : Air, initially at 220 kPa and 450 K undergoes a polytropic state change to 374 kPa and 495 K. What is the polytropic exponent of this process? Saturated water vapor is contained in a rigid container. Heat is then added until the pressure and temperat..

What is the outlet to inlet area ratio of this diffuser : Design a ceiling diffuser. Air flows in the duct behind the diffuser and enters the diffuser at a pressure of 12.8psia, and a velocity of 200in/sec. The outlet of the diffuser is in the room, with atmospheric pressure of 14.5 psi. For the comfort of ..

Wedges-learning goal : The crate shown is held against wedge B by a spring. The spring is 94.5% of its original uncompressed length l=2.75m, and the spring constant is given as k=1650N/m. The coefficient of static friction at all contacting surfaces is ?s=0.130. The mass o..

Obtain the half-range cosine series for the function : A periodic function f(t)is of period 10 defined by f(t)=N+t2, 0

Calculate the average velocity in each section : Air at 60° F and 40 psia is flowing in a 4" diameter pipe at 0.2 slugs/sec. The pipe undergoes a conversion to a 2" by 3" rectangular duct in which T = 150°F and P = 7 psia. Calculate the average velocity in each section.

Calculate the fugacity of liquid hydrogen sulfide : Calculate the fugacity of liquid hydrogen sulfide in contact with its saturated vapor at 25.5C and 20 bar. The vapor pressure of pure water at 310.6 K is 6.455 kPa. Compute the fugacity of pure liquid water at 310.6 K when it is under a pressure of 1..

Liquid-vapor water mixture in a rigid tank : Â½ kg of a liquid-vapor water mixture in a rigid tank initially at 2 bar is heated by 120V heater for 5 minutes until it becomes a saturated vapor at 4 bar. Changes in kinetic and potential energies can be ignored.

Determine the heat transfer and work transfer : Ten pounds-mass of R-22 is at an initial volume of 4.059 ft3 and pressure of 200 psia. It is compressed isobaric ally until its volume is two-thirds of its initial volume. The piston is then held in place as the refrigerant cools until its temperatur..

User Account

All Pages