Obtain a transfer function using the laplace transform

Assignment Help Electrical Engineering
Reference no: EM131285404

Homework

The next problem(s) addresses the following course learning objective(s):

- Understand forward and inverse Laplace transform.
- Obtain the initial value and final values using Laplace transform.
- Obtain a transfer function using the Laplace transform.

Problem 1

Use the defining integral to

a) find the Laplace transform of cosh βt;

b) find the Laplace transform of sinh βt.

Problem 2

Use the appropriate operational transform from Table 12.2 to find the Laplace transform of each function:

a) t2e-at;

b) d/dt(e-at sinh βt);

c) t cos ωt.

Problem 3

Find f (t) if

F(s) = 6s2 + 26s + 26/((s + 1)(s + 2)(s + 3))

Problem 4

Find f(t) if

F(s) = (10(s2 + 119))/((s + 5)(s2 + lOs + 169))

Problem 5

Find f (t) if

F(s) = 40/(s2 + 4s + 5)2.

Problem 6

Find f (t) if

F(s) = (2s3 + 8s2 + 2s - 4)/(s2 + 5s + 4)

Problem 7

Using the initial- and final-value theorems, find the initial and final values of f(t) given as below:

a). F(s) = (7s2 + 63s + 134)/(s + 3)(s + 4)(s + 5)

b). F(s) = (4s2 +78 +1)/ s(s + 1)2

c). F(s) = 40/(s2 + 4s + 5)2

Problem 8

The switch in the circuit in Fig. P12.30 has been in position a for a long time. At t = 0, the switch moves instantaneously to position b.

a) Derive the integrodifferential equation that governs the behavior of the current i o for t ≥ 0+.

b) Show that

Io(s) = - Idc [s + (1/RC)]/[s2 + (1/RC)s + (1/LC)].

197_Figure.jpg

Verified Expert

This is an assignment about laplace transform. Some problems are for laplace transform. Some other for inverse laplace transform. During inverse laplace transform partial expansion is done.

Reference no: EM131285404

Questions Cloud

Who is trying to improve the education system in america : How much does it cost? Why is it helpul for an author who is trying to improve the education system in america? What are the different resoutions during those symposiums for high school students.
What is the decision facing the filter : What is the decision facing The Filter?- What factors are important in understanding this decision situation?- What are the alternatives?
Customer focus-continuous improvement and teamwork : There are three principles of total quality: customer focus, continuous improvement, and teamwork. Using the South University Online Library, find three articles that describe current practices in healthcare organizations.
Determine the circular frequency of small oscillations : A thin ring of radius R and mass m is suspended from a peg of radius r. Determine the circular frequency of small oscillations about the equilibrium position shown if the ring does not slip on the peg. Assume simple harmonic moti
Obtain a transfer function using the laplace transform : Understand forward and inverse Laplace transform and obtain the initial value and final values using Laplace transform and Derive the integrodifferential equation that governs the behavior of the current
How you can improve the physical environments of children : Explain how you can improve the physical, emotional, and cognitive environments of the children you serve, or want to serve. This is not what you already do, but how you can improve.
Director of a long-term care facility : The Midterm Exam is an applied case study scenario where you are the executive director of a long-term care facility that has decided to pursue Joint Commission accreditation.
Calculate the frequency of small oscillations : The homogeneous sphere of mass m and radius r rolls without slipping on a cylindrical surface of radius R. Calculate the frequency of small oscillations about the equilibrium position shown
What is behavioral segmentation : What is behavioral segmentation?- What are some of the ways marketers segment industrial markets?- List and explain the major demographic characteristics frequently used in segmenting consumer markets.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine number of data points used by the fft algorithm

It requires the frequency resolution to be less than 0.5 Hz. Determine the number of data points used by the FFT algorithm and actual frequency resolution in Hz, assuming that the data samples are available for selecting the number of data points.

  Define frequency divider

Important information about Frequency Divider, Design a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input

  Implementation of the project:

Implementation of the project with the analog and digital modulation techniques

  Indicate the magnitude and direction of the shear streses

Indicate the magnitude and direction of the shear streses on the bottom of the block and the plate. If the force is removed suddenly and the block begins to slow, sketch the resulting speed versus time curve for the block.

  Four methods of injecting reactive power

Four methods of injecting reactive power are available, involving the use of?

  What probability that a and b stop on exactly number toss

Suppose that the probability that a head appears when a coin is tossed is p and the probability that a tail occurs is q = 1 - p. Person A tosses the coin until the first head appears and stops. Person B does likewise. The results obtained by perso..

  Calculate the resistance required to reduce the speed

a dc series with an unsaturated field and negligible resistance, when running at a cirtain speed on a given load takes 50A at 460V. If the load -torque variase as the cube of the speed. Calculate the resistance required to reduce the speed 25%.

  Define the necessary number of states

Design an FSM that recognizes an input sequence that has at least three 1's. More specifically, the FSM has one input, X, and one output, Y. Define the necessary number of states and what each state represents

  What is the current available from the secondary

A step down transformer is supplied with 100 V on the primary, from a source capable of only 1 A. if the voltage on the secondary of the transformer is 20 V, what is the current available from the secondary

  Define synthesizer architecture to provide desired signals

The receiver uses a 10.7 MHz IF. For cost, power, weight and size reasons, it is desirable to use a single clock oscillator that will provide the frequency reference for the synthesizer, as well as providing the clock for data.

  Determine cutoff frequency and order for anti-image filter

a dsp system is given with the following specifications: design requirements: sampling rate 20,000 Hz Maximum allowable gain variation from 0 to 4,000 Hz = 2dB 40dB rejection at the frequency of 16000 Hz

  What about the other way around

What about the other way around? Can any NARX model be represented by a state-space model of the form described in Section 15.2? Justify your answer.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd