Reference no: EM133034675
ICTTEN525 Install, Configure & Test Local Area Network Switches
Task 1 - Network Switch Installation
Guidelines:
Using Cisco Packet Tracer, create a network with the following specifications:
- 2 Routers (1841)
- 2 Switches (2960)
- 1 Server (Web Server)
- 10 Workstations
A. Introduction
a. Description of what you will do during this task (1 paragraph)
b. Description of the test you are going to conduct during this task (1 paragraph)
B. General Documentation
a. Network Topology
b. IP Addresses
Device Name IP Address Subnet Mask Speed Duplex
<10 / 100 Mbps> <half / full>
c. Naming Standards (remember that the name of your devices must match the name in the topology)
C. Implementation
a. Screenshot of your configuration, crop your screenshot making sure all the relevant information is captured and make a small comment of what the screenshot is about (You must take screen shot of the configuration process. The #showrun command can be used in the testing phase)
b. First, set up all the basic configuration settings (IP Address, Device Name, Routing Protocol, etc.)
c. Second, test all the basic configuration works and that you have proper connectivity in your network
d. Third, implement:
i. Static IP address to the switches
D. Sign Off
i. Configure speed and duplex of the switch (For each of the connected port, duplex: full, speed: 10 Mbps for workstations and 100 Mbps for server and routers)
ii. Configure SNMP Protocol on the routers and switches (check the uptime, change the name and location of each devices)
iii. Monitor the traffic coming the server using SPAN (Switched Port Analyser)
E. Referencing
a. The Referencing style that we use is APA style.
Task 2 - Network Switch Installation #2
A. Introduction
a. Description of what you will do during this task (1 paragraph)
b. Description of the test you are going to conduct during this task (1 paragraph)
B. General Documentation
a. Network Topology
b. IP Addresses
c. Naming Standards (remember that the name of your devices must match the name in the topology)
C. Implementation
a. Screenshot of your configuration, crop your screenshot making sure all the relevant information is captured and make a small comment of what the screenshot is about (You must take screen shot of the configuration process. The #showrun command can be used in the testing phase)
b. First, set up all the basic configuration settings (IP Address, Device Name, Routing Protocol, etc.)
c. Second, test all the basic configuration works and that you have proper connectivity in your network
d. Third, implement:
i. Static IP address to the switches
D. Sign Off
i. Configure speed and duplex of the switch (For each of the connected port, duplex: full, speed: 10 Mbps for workstations and 100 Mbps for server and routers)
ii. Configure SNMP Protocol on the routers and switches (check the uptime, change the name and location of each devices)
iii. Monitor the traffic coming the server using SPAN (Switched Port Analyser)
E. Referencing
a. The Referencing style that we use is APA style.
Attachment:- Network Switch Installation.rar